Powerstick Luna: Ultra-Portable, Water-Resistant Wireless Speaker

Product Overview

The Luna is an ultra-portable, water-resistant wireless speaker designed for rich and powerful playback. It features Bluetooth® 4.2 connectivity, a 30-feet range, and a 5-watt speaker with a passive radiator for enhanced bass.

Key Features:

• Bluetooth® 4.2 with low-energy consumption
• 30-feet Bluetooth® connectivity range
• 5-watt speaker for rich & powerful playback
• Passive radiator for bass boost
• Water-resistant for the outdoors
• Easy access buttons for quick music control
• Built-in microphone for conference calling
• More than 6 hours of playtime

Product Support:

For more information, visit www.powerstick.com.

For technical support, email: support@powerstick.com.

Designed in Canada by POWERSTICK.COM. Assembled in China.

Specifications

Overview of Controls

The Luna speaker features several controls:

• Pause/Play/Answer: Press to play/pause music or answer/end calls.
• Previous Song / Hold: Volume Down: Press to go to the previous song, press and hold to decrease volume.
• Next Song / Hold: Volume Up: Press to go to the next song, press and hold to increase volume.
• Mic: Built-in microphone for calls.
• Indicator Light: Shows pairing and connection status.
• Charging Port: Micro-USB port for charging.
• Power Button: Press and hold to turn the speaker On/Off.

Setting Up Your Speaker

1. Press and hold the Power button to turn On LUNA. You will hear a startup notification. The Indicator Light will begin flashing red and green, indicating Pairing Mode.
2. Go to your device's Settings and find your Bluetooth® settings. (If you encounter issues, refer to your device's support manual.)
3. You should see LUNA listed in your device's nearby Bluetooth® devices. If not, ensure LUNA is in Pairing Mode (Indicator Light flashing red and green).
4. Tap on LUNA to pair. Once paired, you will hear a notification, and the Indicator Light will flash green.
5. Play your favorite music on LUNA.
6. When finished, press and hold the Power button to turn Off LUNA.

Note on Pairing: To pair LUNA with a new device, disconnect from the current device by turning off its Bluetooth®, forgetting LUNA in its settings, or moving it out of range.

Using Speakerphone

When your speaker is playing music and you receive a phone call, you will hear the ring through LUNA. Press the play/pause button to answer the call. Press it again to hang up. You can also manage calls using your smartphone.

Charging Your Speaker

When the battery is low, connect the included charging cable to the Charging Port on LUNA and the other end to a USB power source (computer, USB charger, etc.).

Product Temperature Range: 0℃-45℃

Regulatory Information

The device has been evaluated to meet general RF exposure requirements and can be used in portable exposure conditions without restriction. The Federal Communication Commission (FCC) Radiation Exposure Statement indicates that the power is so low that no RF exposure calculation is needed.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications or changes to this equipment. Such modifications or changes could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.