BED FRAME ASSEMBLY

After unpacking the product, dispose of the packaging material cardboard and polyethylene film in a container marked paper and plastic. After unpacking the product, assemble the product as follows:

Parts List

Pin 10x40 - 12 pcs
Sector screw - 4 pcs
Sector washer - 8 pcs
Screw M6x65 - 4 pcs
Sector wrench - 1 pc
Matic Washer - 4 pcs
Felt washer - 8 pcs

List of Parts

A: Rear headboard (1 pc)
B: (1 pc)
C: (1 pc)
D: Front forehead (1 pc)

Characters and their explanation

A, B, C: mounting hardware
Bed parts
1, 2, 3: assembly procedure
(i): sequence of steps

Assembly Procedure

Assembly of the rear headboard with side panels.

ATTENTION! Turn the sidewall by drilling down!
Step II: Fitting to the rear face.

Diagram shows attaching part A to part B/C using screws and washers.
Step III: Front face mounting.

Diagram shows attaching part A to part D using screws and washers.
Step IV: With side panels.

Diagram shows attaching part D to part B/C using screws and washers.
Step V: Front face mounting with side panels.

Diagram shows attaching parts D and B/C together using screws and fittings.

Assembly Step 2

Diagram showing the assembled bed frame with parts labeled A, B, C, D, E, F.

List of Parts

E: Centre line (1 pc)
F: Centre line leg (1 pc)

Parts List

Self-tapping screw 4-16 - 8 pcs
Self-tapping screw 4x45 - 3 pcs
Fittings - 2 pairs
Self-tapping screw 4x20 - 4 pcs

Assembly Steps

Step I: Diagram shows attaching fittings to part E.
Step II: Fitting to the rear face.

Diagram shows attaching fittings to the rear face of the bed frame.
Step III: Fitting the centre leg to the centreline.

Diagram shows attaching part F to part E using screws.
Step IV: Screw the centreline fitting onto the other part of the fitting (on the front and rear face) in the marked holes.

Diagram shows securing the centreline fitting.

Instructions for use

Check the screws six months after you start using them and once a year thereafter and tighten them firmly if they are loose. Do not drag the product on the floor, but lift it up.

Maintenance instructions

Treat the painted wooden parts with common products, e.g. COLORMAT, DIAVA, OPTI, etc. designed for the treatment of painted furniture. Never clean wooden parts with petrol or acetone.