SHAD
KTM DUKE 390 ADVENTURE '20
KIT TOP - KODK30ST
DESIGNED IN BARCELONA
1
262626 x1
2
260417 x2
Ø16 Ø9 x 16
3
303045 x2
Ø8
4
304169 x2
M8 x 50 Din 7380
5
262627 x1
6
260213 x2
Ø16 Ø9 x 12
7
261497 x2
Ø20 x Ø8 x 30,5
8
303017 x2
Ø6
9
304117 x2
M6 x 70 Din 912
10
304091 x2
M6 x 20 Din 7991
11
303000 x2
Ø6
12
302021 x2
M6
! WARNING!
GB Do not fully tighten the screws until it is ensured that the KIT is correctly attached and aligned.
ES No apretar los tornillos del todo hasta asegurarse que el KIT está correctamente colocado y alineado.
DE Ziehen Sie die Schrauben nicht ganz fest, bevor Sie sich nicht vergewissert haben, daß der Bausatz korrekt eingestellt und ausgerichtet ist.
IT Non stringere del tutto le viti fin tanto non si è sicuri che il kit è collocato correttamente e allineato.
FR Ne pas serrer les vis avant d'être sûr que le KIT soit correctement positionné et ajusté.
Step 1
Attach part A to the motorcycle seat using the indicated hardware.
Diagram shows part 1 being attached to the rear of the motorcycle seat, with arrows indicating upward and forward motion. Labels A and B point to specific locations on the seat.
Step 2
Secure part B to the motorcycle seat.
Diagram shows part B being attached to the motorcycle seat, with screws and washers indicated.
Step 3
Assemble parts 5, 6, 7, 8, and 9 as shown.
Diagram shows the assembly of several parts, including part 5 (a bracket) being attached to the motorcycle with parts 6, 7, 8, and 9 (screws and washers). A checkmark indicates correct assembly.
Step 4
Attach part 2 to the motorcycle using parts 1, 4, 3, and 10.
Diagram shows part 2 being attached to the motorcycle, with parts 1, 4, 3, and 10 (screws and brackets) used for securing it.
Step 5
Attach part 5 to the assembly from Step 4 using parts 11 and 12.
Diagram shows part 5 being attached to the previously assembled components using parts 11 and 12 (screws).
Step 6
Final check of the installation.
Diagram shows the completed installation with a checkmark indicating correctness.
