Bright Wireless Thermometer
Item no. 021295, 021296
Operating Instructions
Important! Read the user instructions carefully before use. Save them for future reference.
Safety Instructions
- Read the instructions.
- CE Approved in accordance with the relevant directives.
- Recycle discarded product in accordance with local regulations. [recycling symbol]
Technical Data
| Parameter | Value |
|---|---|
| Transmitter frequency (wireless communication) | 433.92 MHz |
| Transmission range | ≤60 m |
| Battery (sold separately) | 2x LR03 AAA |
| Measuring range (indoors) | 0°C (32°F) – 50°C (122°F) |
| Measuring range (outdoors) | -39.9°C (-39.8°F) – 59.9°C (139.8°F) |
| Size (indoor unit) | 60x22.5x90 mm |
| Size (outdoor sensor) | 92x40x23 mm |
Description
Display Elements
The thermometer display shows:
- 1. Indoor temperature
- 2. Outdoor temperature
- 3. Highest/lowest outdoor temperature
- 4. Signal indicator
- 5. Clock
- 6. Time format
Diagram Description
Diagram 1 (Display Unit): Shows the main display unit with current indoor temperature (e.g., 20.3°C), current outdoor temperature (e.g., 22.8°C), RF signal indicator, and the current time (e.g., 10:08).
Diagram 2 (Receiver Back): Shows the back of the receiver unit with the battery compartment and three function buttons labeled 1, 2, and 3.
Function Buttons
- 1. IN/OUT button: Used to switch between indoor and outdoor temperature display.
- 2. MEM/+ button: Used to display highest/lowest temperatures and reset them.
- 3. SET/°C/°F button: Used for setting the clock, selecting temperature units (°C/°F), and confirming settings.
Use
Before Using for the First Time
- Open the battery compartment on the back of the receiver and insert the batteries with the correct polarity. Replace the battery compartment cover.
- Open the battery compartment on the back of the transmitter and insert the batteries with the correct polarity. Replace the battery compartment cover.
- When the batteries are inserted, all symbols on the display will appear simultaneously for 3 seconds.
- The receiver searches for a connection to the transmitter. This takes about 3 minutes, and a flashing RF antenna icon will appear in the outdoor field of the receiver display.
Manual Setting of Clock
- Press and hold button (3) for approximately 3 seconds to confirm. The 12/24-hour display will flash. Press button (2) to set the 12/24-hour format.
- Press button (3) again to confirm. The hour display will flash. Press button (2) to set the correct hour.
- Press button (3) again to confirm. The minute display will flash. Press button (2) to set the correct minutes.
- Press button (3) again to confirm and finish, and to switch to clock mode.
- If no button is pressed for 30 seconds, the clock will automatically switch from setting mode to normal mode.
Temperature Display in °C/°F
Select the temperature display in °C or °F by briefly tapping button (3).
Display of Highest and Lowest Measured Temperature
Switch between the display of the current temperature and the highest/lowest temperatures measured since the last reset (indoor and outdoor) by pressing button (2).
- Press once to show the highest measured indoor and outdoor temperature.
- Press twice to show the lowest measured indoor and outdoor temperature.
- Press three times to go back and show the actual temperatures.
Hold button (2) for approximately 3 seconds to reset the highest and lowest temperatures.
Switching Between Displaying the Indoor and Outdoor Temperature
Tap button (1) to switch between showing the indoor and outdoor temperature on the display.