Home › Vacon › VACON 20 X Control Keypad Mounting Instructions PDF
ℹ️ Document Conversion Notice: This page was converted from the original file for easier reading. Diagrams/images may appear only in the original PDF below.
Document preview
File info: application/pdf · 2 pages · 178.80KB

VACON 20 X Control Keypad Mounting Instructions

1. VACON 20 X - CONTROL KEYPAD

1.1 MOUNTING INSTRUCTIONS

Document code: DPD00985A

1.1.1 MOUNTING ONTO THE DRIVE

Figure 1: Drive and the optional keypad kit. The VACON drive unit is depicted alongside the optional keypad kit. This kit includes the keypad and its connecting cable. The drive unit features indicator lights labeled PWR, RUN, FLT, and RDY.

Figure 2: Disconnection of the HMI cap from the drive. This illustration shows the procedure for detaching the HMI (Human-Machine Interface) cap from the VACON drive unit.

Figure 3: Mounting of the keypad. This diagram illustrates the process of physically attaching the keypad to the drive unit.

Figure 4: Tighten the two screws of the keypad cable to the enclosure of the drive. Keypad mounted onto the drive. This image shows the final step where two screws are tightened to secure the keypad cable to the drive's enclosure, completing the keypad's mounting onto the drive.

For service support, find your nearest Vacon service center at www.vacon.com.

Models: 20 X, Vacon 20 X Control Keypad, Vacon 20 X, Control Keypad, Keypad

Original Document

If the viewer doesn’t load, open the PDF directly.

References