2025 Scott Addict RC User Manual and Technical Data

Introduction

The Addict RC must be perfectly adjusted to the rider to ensure maximum safety and rideability. Contact your authorized SCOTT dealer for information to avoid technical problems or damage.

Legend

Tool Size Examples: T25 Torx, Hex

Torque Examples: 5 Nm, 6 Nm, 8 Nm, 2 Nm, 4 Nm, 12 Nm

Application Examples: With Grease, Without Grease, Carbon Grease, Loctite Medium Threadlocker

Geometry and Technical Data

Frame Sizes and Geometry

Rotor Dimensions

This section illustrates the correct brake rotor sizes and adapter requirements for the fork and rear frame. Always tighten screws according to the brake manufacturer's recommendations.

• Fork: Minimum 180mm rotor adapter (Shimano Y8N230000, highlighted in red). Maximum 160mm rotor (Shimano, indicated by green dashed line). SRAM Flat Mount Adapter: 00.5318.018.000.
• Rear: Minimum 140mm rotor (Shimano/SRAM flat mount, direct mount without adapter). Maximum 160mm rotor (Shimano FLATMOUNT R160D/D, +20mm, highlighted in red). SRAM Flat Mount Adapter 160: 00.5318.018.001. Screw length is the same for 140mm and 160mm rotors.

Seatpost Collar

The seatpost collar is a single-piece unit and is only available as a complete part. Its profile includes a non-slip surface to prevent the collar from sliding down the seat tube after seatpost installation. Use carbon paste where indicated.

Torque: 6 Nm [torque wrench] using a T25 Torx [tool].

Cable Installation Guides

Spare Parts

This section lists available spare parts for the 2025 Addict RC. Torque specifications are indicated where applicable.

• SCO DROPOUT ADDICT RC DIRECT 25 (T20, 2 Nm)
• SCO DROPOUT ADDICT RC STANDARD 25 (T20, 2 Nm)
• SCO AXLE ADDICT RC R 25 (6, 12 Nm)
• SCO AXLE ADDICT RC F 25 (6, 12 Nm)
• SCO SEATPOST CLAMP ADDICT RC 25 (T25, 6 Nm)
• SCO HEADSET EXPANDER ADDICT RC 25 (6, 8 Nm)
• SCO STEM SPACER/TOP CAP KIT ADDICT RC 25
• SCO HEADSET TOP CAP ADDICT RC ULT 25
• SCO HEADSET TOP CAP ADDICT RC 20/30 BLK 25
• SCO HEADSET TOP CAP ADDICT RC 30 Grey 25
• SCO HEADSET TOP CAP ADDICT RC 10 YEL 25
• SCO HEADSET TOP CAP ADDICT RC 20 Pink 25
• SCO HEADSET TOP CAP ADDICT RC 30 Pink 25
• SCO HEADSET TOP CAP ADDICT RC Pro 25
• SCO SEATTUBE CABLE TUBE DI2 ADDICT RC 25
• SCO BATTERY HOLDER DI2 ADDICT RC25
• SCO CABLE GUIDE KIT ADDICT RC 25
• SCO STEM HARDWARE KIT CRESTON IC SL 25
• SCO STEM CABLE COVER ADDICT RC 25 (T25, 4 Nm)
• SYN STEM ST-R100-AL (handlebar clamp and steerer clamp torque) (T25, 5 Nm)
• SYN SEATPOST SP-R101-CF 15MM OFF
• SYN S.POST SP-R101-CF 0MM OFF
• SYN HANDLEBAR HB-R100-AL
• SYN HANDLEBAR HB-R100-CF
• SYN COCKPIT IC-R100-SL 420MM
• SYN COCKPIT IC-R100-SL 400MM
• SYN COCKPIT IC-R100-SL 380MM
• SYN COCKPIT IC-R100-SL 360MM
• SYN REAR LIGHT CAMPBELL 20 D IL
• SCO FD ALLOY WASHER ADDICT RC 25

Manufacturer Warranty

By purchasing a new SCOTT bicycle from an authorized SCOTT dealer, SCOTT grants a manufacturer's warranty subject to the following provisions.

Conditions

The manufacturer's warranty is granted only to the first purchaser of a SCOTT bicycle, who purchased it from an authorized SCOTT dealer. The manufacturer's warranty applies only if the bicycle is registered in the name of the first purchaser at www.scott-sports.com within one year of purchase.

Duration

The manufacturer's warranty is granted from the date of purchase for a period of five years on frames and rear triangles. The warranty period is reduced to three years if the SCOTT bicycle is not serviced at least once a year by an authorized SCOTT dealer. Maintenance must be performed in accordance with the maintenance instructions contained in the SCOTT manual and must be confirmed by the stamp and signature of the authorized SCOTT dealer. For frames and rear triangles of Category 5 bicycle models and for rigid forks produced by SCOTT, the duration of the manufacturer's warranty is limited to two years. If a defective component of the SCOTT bicycle is replaced within the scope of the legal or manufacturer's warranty, the duration of the manufacturer's warranty will not be extended. The manufacturer's warranty terminates if the first purchaser transfers ownership of the SCOTT bicycle to a third party.

Claim

The manufacturer's warranty is provided by SCOTT Sports SA, Route du Crochet 11, 1762 Givisiez, Switzerland. The purchaser must inspect the SCOTT bicycle immediately after purchase and promptly inform their authorized SCOTT dealer in writing of any obvious defects. Hidden defects must be reported immediately upon discovery. In the event of a warranty claim, the SCOTT bicycle must be delivered to an authorized SCOTT dealer. The latter will contact SCOTT to remedy the defect. A warranty claim always requires the presentation of the original proof of purchase, as well as proof of maintenance service contained in the SCOTT manual.

SCOTT's Performance in Case of Warranty Claim

In the event of a warranty claim, SCOTT will, at its discretion, repair the defect or replace the defective product with a product of similar quality, for which deviations in color and model are possible. If repair or replacement is not possible, a refund of the purchase price will be made, taking into account previous use. SCOTT reserves the right to assign the task of correcting the defect to third parties.

Limitations

The manufacturer's warranty applies exclusively to frames, rear triangles, and rigid forks of SCOTT bicycles. Bicycle components are excluded from this manufacturer's warranty. The manufacturer's warranty does not apply to normal wear and tear, damage caused by accidents or other excessive force exerted on the SCOTT bicycle, corrosion, improper maintenance, incorrect assembly, and the installation of unsuitable components or accessories, as well as cosmetic defects, such as paint. The manufacturer's warranty does not apply to SCOTT bicycles that have been used in a rental shop.

Miscellaneous

These manufacturer's warranty provisions apply to all SCOTT bicycles from model year 2023 onwards. The buyer's statutory warranty rights and the warranties of component manufacturers (Shimano, SRAM, etc.) remain unaffected by this manufacturer's warranty. The competent court for all disputes relating to this manufacturer's warranty is Fribourg, Switzerland. This manufacturer's warranty is subject to Swiss law, excluding all laws referring to the law of other countries.