Zipwake Startup Checklist

Zero Pitch & Roll Angles?

Check if the system displays zero pitch and roll angles.

If NO: Tap $\equiv$, then tap AUTO Setup, then tap Boat Data, and change if incorrect. Then, tap $\equiv$, tap Angles Setup, tap Reset Pitch & Roll, and confirm the orientation angle (Refer to Operator's Manual).

If YES: Proceed.

Boat Data:

• Boat Length: 9 m
• Boat Beam: 2.5 m
• Boat Weight: 5000 kg
• Hull Type: Mono

Red GPS Symbol Visible?

Check for a red GPS symbol on the display.

If NO: Tap $\equiv$, then tap Select GPS Source, then tap Change Source, and continue.

If YES: Tap $\equiv$, then tap Select GPS Source, then tap Change Source, and continue.

Auto Mode On?

Check if Auto Mode is active.

If NO: Tap FULL AUTO.

If YES: GO!

Main Menu Overview

The Integrator Module provides access to various system settings:

• System information: View system units, status, and data.
• AUTO Setup: Edit AUTO Pitch Curve and boat data.
• Interceptor Setup: Configure AUTO Cleaning and run interceptor tests.
• Angles Setup: Select and view the current status of Pitch & Roll and Integrator Module Orientation.
• Select GPS Source: Configure GPS settings and view current status.
• Set Units: Adjust units for Speed, Length, Weight, etc.
• Select Language: Choose the system language.
• Advance Setup: Access upgrade options, pitch curve export/import, and factory reset.

To Reset Pitch & Roll Angles:

1. Level the boat.
2. Tap $\equiv$.
3. Tap Angles Setup.
4. Tap Reset Pitch & Roll.
5. Confirm Orientation Angle (Refer to Operator's Manual).

Change GPS Source

To change the GPS source:

1. Tap $\equiv$.
2. Tap Select GPS Source.
3. Tap Change Source.
4. Continue.

Diagram Description: Stansat hål

A circular diagram indicating a punched hole ('Stansat hål') with a diameter of 45 mm, with a tolerance of +/- 0.5 mm. Dashed lines indicate the center and perpendicular axes. An arrow points to the edge of the circle, labeled 'Uppklippt' (cut out).