Apollo Pagers Programming Instructions

AL801: Buttons labeled 1, 2, 3
AL924: Buttons labeled 1, 2, 3
AL812: Buttons labeled 1, 2, 3

Pager Models

The following Apollo pager models are shown with their programmable buttons:

Note: Arrows in the original document indicate which button corresponds to the labels 1, 2, and 3 for each model.

To begin programming, remove the pager battery.
Hold down Button 1 while reinserting the battery. Continue holding Button 1 until "PASS 0000" or the frequency screen appears on the display.
Press Button 3 to navigate to the frequency screen.
To change the frequency:
- Press Button 1 to change the number (e.g., 1, 2, 3).
- Press Button 2 to move to the next digit to the right.
Once the desired frequency is set, press Button 3 to move to the next screen (Capcode).
To change the Capcode, use Button 1 and Button 2.
To change the Baud Rate:
- Press Button 2 to cycle through the available rates: 512, 1200, 2400.
- Press Button 3 when the desired Baud Rate is displayed.
The screen will display "Pass 0000". This is the final screen where a password can be entered to protect the pager.
To enter a password:
- Use Button 1 to change the number.
- Use Button 2 to move to the next digit to the right.
Finally, press Button 3 until "PASS" is displayed. The pager will beep, confirming it has been programmed.

For more information, please visit: www.apollowireless.com