ASSEMBLY INSTRUCTIONS

Tools Required

• Phillips Screwdriver (Not Included) ?
• Power Tool (Not Included) ?️
• 2 People Recommended ?‍?‍?

Pre-Assembly Introduction

• Assemble near the area of the intended location.
• Make sure you have enough space to move around.
• Use cardboard or blankets to prevent scratches.
• Ensure the furniture rests on a flat and level surface.

Assembly and Care Advice

• Position each part correctly and insert screws or bolts into their respective holes.
• Turn clockwise to tighten and only tighten when step is completed or when instructed to do so.
• Use the appropriate hand tools or power tools for assembly.
• Select steps, such as tightening screws and/or bolts, may require hand tools to avoid causing damage during assembly.
• After two weeks, check and tighten any loose hardware and repeat again every six months thereafter.

Important Warnings

• This unit has been designed to support the maximum loads shown. Exceeding these load limits could cause sagging, instability, product collapse, and/or serious injury.
• DO NOT allow children to climb on unit.
• Put heavier items on lower shelves.

Parts and Hardware

Parts

• A: 2 Pieces
• B: 1 Piece
• C: 8 Pieces

Hardware

• 1: 5 Pieces
• 2: 5 Pieces
• 3: 2 Pieces
• 4: 3 Pieces
• 5: 1 Set

Assembly Steps

Step 1: Assemble Top Section

• Identify Part A (2 pieces - side panels) and Part B (1 piece - top shelf).
• Identify Hardware 1 (5 pieces - screws) and Hardware 2 (5 pieces - dowels/connectors).
• Attach Part B to the top of Part A using Hardware 1 and Hardware 2.
• Diagram Description: Illustrates connecting the two side panels (A) to the top shelf (B). Dowels (2) are inserted into pre-drilled holes, and then screws (1) are used to secure the connection. A detail shows a cap being removed from a dowel (Hardware 2) before insertion, referencing Part 1 (likely the dowel itself).
• Note: Ensure the pre-drilled holes on panels (A) are facing backward.

Step 2: Attach Shelves

• Identify Part C (8 pieces - shelves).
• Identify Hardware 3 (2 pieces) and Hardware 4 (3 pieces - screws).
• Attach the shelves (Part C) to the vertical panels (Part A) using Hardware 3 and Hardware 4.
• Diagram Description: Shows the frame assembled in Step 1. The middle and bottom shelves (C) are being attached to the inside of the side panels (A). Screws (4) are used for attachment. The diagram indicates where each shelf should be placed.

Step 3: Secure to Wall (Recommended)

• For safety, it is recommended to use the provided hardware (Hardware 5 - 1 Set) to secure the unit onto the wall. This helps prevent tipping.
• Diagram Description: Depicts the fully assembled display shelf. It shows brackets and screws being used to fasten the top of the unit to a wall.

Step 4: Load Capacity

• Top Shelf: Maximum 20 lbs (Evenly Distributed)
• Middle Shelf: Maximum 40 lbs (Evenly Distributed)
• Bottom Shelf: Maximum 40 lbs (Evenly Distributed)

ASSEMBLY COMPLETED