Allen + Roth Brynmar 36-Inch Vanity Combo
Model Numbers: L23119-VS36-CB / L23119-VS36-LN
Item Numbers: 7390137 / 7390131
Brand: Allen + Roth
Manufacturer: LF, LLC
Customer Support: ? Call 866-439-9800 (Mon-Sun, 8 a.m. - 8 p.m. EST) or ✉️ email ascs@lowes.com.
Please attach your receipt for warranty purposes.
Product Specifications
Diagrams below show product dimensions. Measurements are provided in both inches and millimeters.
Front View
Dimensions: Width: 914 mm (36 inches), Height: 982 mm (38 11/16 inches), Depth: 549 mm (21 5/8 inches).
This view illustrates the overall front appearance, including the configuration of doors and drawers.
Back View
Dimensions: Width: 914 mm (36 inches), Height: 889 mm (35 inches), Depth: 294 mm (11 9/16 inches).
This view shows the rear of the vanity, indicating its depth and potential access points for plumbing.
Side View
Dimensions: Height: 982 mm (38 11/16 inches), Depth: 549 mm (21 5/8 inches), Width: 305 mm (12 inches).
This view details the side profile of the vanity.
Top View
Dimensions: Width: 914 mm (36 inches), Depth: 549 mm (21 5/8 inches).
This view shows the top surface, including the sink placement and faucet hole configuration. The sink has a diameter of approximately 45 mm (1 3/4 inches).
Parts List
The following table lists all components included with the vanity. An exploded view diagram shows the relative placement of these parts.
| Part # | Description | Quantity | Code |
|---|---|---|---|
| A | Countertop | 1 | EUT36BC-R |
| B | Backsplash | 1 | EUT36BC-BS |
| C | Sink | 1 | CUM20WT-R |
| D | Tilt-down drawer | 1 | L23119-36DW-TILT |
| E | Door - left | 1 | L23119-36DR-LT |
| F | Door - right | 1 | L23119-36DR-RT |
| G | Interior shelf | 1 | L23119-36SH |
| H | Top drawer | 1 | L23119-36DW-T |
| I | Bottom drawer | 1 | L23119-36DW-B |
| J | Knob | 2 | L23119-KNOB |
| K | Drawer handle | 3 | L23119-HANDLE-DW |
| L | Tilt-down drawer handle | 1 | L23119-HANDLE-TILT |
| M | Tilt-down drawer bend - left | 1 | PT-BEND-TILT-LT |
| N | Glider - right | 2 | PT-GT-RT |
| O | Glider - left | 2 | PT-GT-LT |
| P | Door hinge | 4 | PT-HINGE-DR |
| Q | Shelf support | 4 | SHELF-SPT |
| R | Leg levelers | 4 | LEG-LVL |
| S | Tilt-down drawer hinge | 2 | PT-HINGE-TILT |
| T | Door alternative knob | 2 | L23119-KNOB-AH-DR |
| U | Drawer alternative handle | 3 | L23119-HANDLE-AH-DW |
| V | Tilt-down drawer alternative handle | 1 | L23119-HANDLE-AH-TILT |
The diagram shows an exploded view of the vanity, with each part labeled A through V, corresponding to the table above.
Assembly Instructions
Tools Required (not included):
- ? Safety goggles
- ? Sealant
- ? Level
Step 1
Place the vanity combo in the desired position, considering the location of your plumbing. Ensure the vanity top is flush against the wall. Adjust the leg levelers so the vanity combo is level.
Diagram shows the vanity positioned against a wall, with an arrow indicating adjustment of leg levelers.
Step 2
Clear the backsplash of all debris before applying clear silicone sealant (not included). Apply a few thin beads of sealant to the unpolished back and bottom edge of the backsplash.
Diagram illustrates applying sealant to the backsplash.
Step 3
Set the unpolished bottom edge of the backsplash onto the vanity countertop and press gently against the wall and down onto the top. Remove any excess sealant from the wall and the vanity top.
Diagram depicts the backsplash being attached to the vanity top and wall.
Step 4
The vanity is ready after drying for 24 hours.
Diagram shows the fully assembled vanity, with a "24H!" indicator for drying time.
Care and Maintenance
Countertop Care
- Rinse the vanity top with clean, hot water when needed. Dry immediately with a soft cloth.
- Blot spills quickly, and wash with mild soap and warm water. Dry immediately with a soft cloth.
- Remove oil or other difficult stains with an Oil Based Sealer. If this does not work, seek professional help.
- If cleaning with chemicals, re-seal the top (after it is completely dry) 1-2 times, and apply clear stone wax for daily protection.
- Larger scratches, chips, and resilient stains may require professional help. Contact your local stonemason for details.
- The vanity top was sealed at the factory, but reapplication is necessary over time. The frequency depends on the quality of the sealer used and the frequency of use. It is recommended to use a penetrating non-toxic sealer for best results.
Cabinet Care
- Dust the vanity frequently with a clean, soft, dry, lint-free cloth, and polish it regularly.
- Clean up excess water and spills immediately. Blot rather than wipe. Water left for extended periods can cause white spots on the finish.
- Clean the surface by rubbing in the direction of the grain. Use furniture cleaners or polishes recommended by your local hardware store, following manufacturer's instructions. Avoid silicone cleaners and waxes.
Maintenance
- To maintain the furniture finish, avoid placing the vanity in direct sunlight.
- Avoid exposing the vanity to extreme temperatures by installing it away from heat and air vents.
- The cabinet is water-resistant, but not waterproof. Periodically check for excess water and dry immediately with a soft cloth.
Warranty Information
Limited 1 Year Warranty
Allen + Roth guarantees satisfaction with each vanity. If a vanity does not meet satisfaction due to a visual defect, return it to the retailer with original packaging and receipt PRIOR TO INSTALLATION for a replacement. The warranty covers all defects in materials and manufacturing for ONE (1) YEAR from the date of purchase. It applies only to the original purchaser acquiring the product directly from the retailer and to products used for normal residential use during the one-year period. Commercial usage is not covered.
Information About Your Warranty Coverage
This warranty does not cover damages or failures attributable to:
- Vanities installed with obvious visual defects.
- Defects or damage caused by installation that does not strictly comply with the instructions in this manual.
- Defects or damage caused by severe accidents (e.g., fire, impacts).
- Damage caused by flooding or standing water from leaks (pipes, faucets, appliances, etc.), including floods and acts of God.
The sole remedy provided by this warranty is the repair or replacement of defective products. This warranty does not cover the cost of removal or installation of new products. The warranty will be void if the item is installed with obvious visual defects.
Printed in Vietnam
