JCHR35W1C/2C 16-channel LCD Remote Controller User Manual
01 Product Info
JCHR35W1C: Hand-held 16-channel LCD Remote Controller
JCHR35W2C: Wall-Mounted 16-channel LCD Remote Controller
03 Models & Parameters
(more info please refer to the nameplate)
| Electrical Specification | Standard |
|---|---|
| Battery Type | Hand-held: CR2450*3V*1; Wall-mounted: CR2430*3V*2 |
| Working Temperature | -10℃ - 50℃ |
| Radio Frequency | 433.92MHz ± 100KHz |
| Transmit Distance | >=30m indoor |
04 Caution!
- The transmitter should not be exposed to moisture or impact, so as not to affect its life.
- During use, when the remote control distance is significantly shorter or less sensitive, please check whether the battery needs to be replaced.
- When the battery voltage is too low, the LCD screen will show a low voltage prompt, prompting to replace the battery.
- Please properly dispose of used batteries according to the local garbage classification and recycling policy.
05 Instructions
a. Channels & Groups Toggling
Channel Toggling: Press Up or Down buttons to cycle through channels 1 to 16.
Group Toggling: Press Up or Down buttons to cycle through groups 1 to 6. Channel 0 is the group control for all channels.
b. Number of Channels Setting
Under Channel 1, press and hold the 'Fav' button for 3 seconds to complete. Use '<' or '>' to choose the channel number. Note: Max/Min number is 16/1 when set under channel 1-16.
c. Number of Groups Setting
Under group 0, press and hold the 'Fav' button for 3 seconds to complete. Use '<' or '>' to choose the channel number. Note: Max/Min number is 6/0 when set under channel 0.
d. Channel in Group Setting
Under the chosen group, press the 'Fav' button. A short press will make the Channel number steady-lit (channel is in the group). Another short press will make the Channel number flashing (channel is not in the group). Release after 3 seconds. Use '<' or '>' to choose the group. Complete.
Note: Channel in groups setting is under GROUP 1-6.
e. Check the Channels in Groups
Under the chosen group, press the 'Fav' button. The group icon will flicker. Use '<' or '>' to check channels. Short press 'Fav' to exit. Note: LCD will show "EC" if there is no detailed channel.
f. Prohibit Dual-key Operation
Press 'Prg' for 10 seconds. The LCD will show a lock icon, prohibiting dual-key operation. Repeat the process to activate dual-key operation. Note: When dual-key operation is prohibited, programming setting functions are not allowed, such as limits setting.
g. Position Percent Setting
Short press the Up or Down buttons thrice to choose the channel number. Use '<' or '>' to decrease or increase the percentage. Stop on the desired percentage and wait 3 seconds. The shades will move to the chosen percentage down position. Note: All shades under the same group will move to the same position after percent setting.