Intellinet Network Solutions - Provider of PoE & Data Center Products
Installation Guide for Intellinet models including: INT-V05-042, INT-V04-042, INT-V05-042 Keystone Jack, INT-V05-042, Keystone Jack, Jack
File Info : application/pdf, 1 Pages, 322.72KB
DocumentDocumentKeystone Jack Quick Install Guide Follow the steps on this quick install guide for easy installation and use of both the shielded and the unshielded Cat5e and Cat6 versions of this product, all of which are compatible with both 110 and Krone punchdown tools. Unshielded Cable: T568A Pin 5 White/Blue Pin 4 Blue Pin 1 White/Green Pin 2 Green Pin 3 White/Orange Pin 6 Orange Pin 7 White/Brown Pin 8 Brown T568B Pin 5 White/Blue Pin 4 Blue Pin 1 White/Orange Pin 2 Orange Pin 3 White/Green Pin 6 Green Pin 7 White/Brown Pin 8 Brown Carefully strip away approximately 30 mm of each cable jacket to be onnected to the Box, separating the wires into four pairs. Shielded Cable: Referring to the pin table above, position the ends of each wire pair in the slot corresponding to the wire color. Use either a 110 or Krone punch-down tool to secure each pair of wires in place on the jack. Replace the IDC cap on the jack to fix the wires in place. Use the cable tie to secure the cable and complete the installation. 1. Slide the cable jacket into the cable holder. 2. Referring to the pin table above, position the ends of each wire pair in the slot corresponding to the wire color. Use either a 110 or Krone punchdown tool to secure each pair of wires in place on the jack. Replace the IDC cap on the jack to fix the wires in place. Use a cable tie to secure the cable and complete the installation. intellinet-network.com Cover the jack with the main shield to complete the installation. NOTE: Be sure that the main metal sheild slips behind the two plastic tabs on the jack. © IC Intracom. All rights reserved. Intellinet Network Solutions is a trademark of IC Intracom, registered in the U.S. and other coun- tries. INT-V04-042_QiG_0316_REV-5.01 INT-V05-042_QiG_0316_REV-5.01.indd 1 3/30/16 12:45 PM