Sandisk Sansa m230 Series mp3 player Teardown
This guide will help those looking to repair a component found inside the device. Follow these steps to gain access to such components.
Written By: James Thorne
Introduction
Follow the steps in this guide in order to gain access to components found inside the device which most often require repair of replacement.
Tools:
- Phillips #0 Screwdriver (1)
- iFixit Opening Tools (1)
Step 1
Remove the battery compartment cover.
Remove the battery.
Step 2
Locate and remove the screw next to the battery compartment lid.
Step 3
Locate the interlocking pegs along the seam of the device's casings.
Gently pry the pegs apart one at a time, working your way around the case.
⚠️ Be careful when prying apart the pegs: they are made of plastic and may break.
Step 4
The battery contact springs may prevent the case from separating.
Push the battery contact springs down through the hole in the case.
Step 5
The casing protecting the USB and headphone jacks must be removed.
Locate and gently pry apart the two interlocking clips holding it in place.
The outer casings may now be removed and the MP3 player should separate.
Step 6
You now have access to all components found on the inside of the device!
To reassemble your device, follow these instructions in reverse order.