8-inch Round Interior Light MANUAL

To properly install this light, you must have a good understanding of automotive electrical procedures and systems, along with proficiency in the installation and use of safety warning equipment.

WIRING

To +12VDC for Bright Mode (fuse @ 1.5A)......... RED

To +12VDC for Dim Mode (fuse @ 1.5A)......... WHITE

To -Chassis Ground...................................... BLACK

A diagram shows the light fixture with three wires: red, white, and black, corresponding to the wiring instructions.

OPERATION

Each unit may be operated in one of the two modes:

Operating in Bright Mode:

With the black wire connected to chassis ground, connect the red wire to +12VDC to illuminate the light at full intensity (Bright mode).

Operating in Dim Mode:

With the black wire connected to chassis ground, connect the white wire to +12VDC to illuminate the light in Dim Mode.

NOTE: Bright Mode has priority over Dim Mode.

INSTALLATION

Create a 7.00" (178mm) cut-out on the selected mounting surface.
Make all wiring connections.
Push the 4 snap-springs inward [A], and insert the light into cut-out [B]; the snap-springs will fix the light into the position.
Test for proper operation.

A diagram illustrates the installation process. It shows a circular cut-out of 7.00" (178mm) in a surface. Another part of the diagram shows the light fixture being inserted into the cut-out, with arrows indicating the snap-springs being pushed inward [A] and the light being inserted [B].