Emerson Quick Reference Guide
Model: ITL9907RE
Introduction
The Glue Cards are designed for use with the Emerson Indoor Flying Insect Trap model ITL7103 (sold separately). It is highly recommended to fully read the main owner's manual of ITL7103 to receive the full safety instructions and operation procedures.
Directions for Use
The insect trap works by using a continuous, attractive light to draw insects. Once they are enticed, they are caught by a highly effective sticky paper, preventing their escape.
Insect Trap Mode
- Remove the adhesive liner from the Glue Card and discard it. Insert the Glue Card into the device with the glue facing the back.
[Description: Peeling the adhesive liner from the Glue Card, then inserting it into the trap body with the sticky side facing the back.] - Plug the device into an indoor outlet and insect trap mode is automatically activated. To optimize the performance, leave the unit powered on continuously.
[Description: The device is plugged into a wall outlet.] - The plug on the device can be rotated if necessary. ⚠️ ALWAYS UNPLUG BEFORE ROTATING THE PLUG.
[Description: The device's plug can be rotated. A warning is present to always unplug the device before rotating the plug.] - Replace the Glue Card when it is full of bugs, dust or debris. It is advisable to check every 2 weeks. ?️
[Description: A full Glue Card covered in insects and debris indicates it's time for replacement. The trash can icon signifies disposal.]