SonicWall SonicWave 432e/432i USB Security Clamp Installation and Assembly Guide

ℹ️ Document Conversion Notice: This page was converted from the original file for easier reading. Diagrams/images may appear only in the original PDF below.
Document preview
File info: application/pdf · 2 pages · 384.08KB

SonicWall SonicWave 432e/432i USB Security Clamp Installation and Assembly Guide

Installation Steps

  1. 1 USB Security Clamp Placement

    The security clamp attaches to the USB port of the SonicWall SonicWave 432e/432i wireless access point.

    [Diagram: Shows the USB security clamp positioned near the USB port of the SonicWave 432e/432i wireless access point. An arrow indicates the clamp is to be attached to the USB port.]

  2. 2 Attaching the Clamp to the Appliance

    Use the screw torq to fasten the USB clamp to the bottom of the appliance.

    [Diagram: Shows the bottom of the SonicWave appliance. The USB clamp is positioned, and an arrow indicates fastening it with a screw.]

  3. 3 Inserting the USB Device

    Insert the USB device into the USB port.

    [Diagram: Shows a USB device and the USB port on the SonicWave device. An arrow indicates the USB device being inserted into the port.]

  4. 4 Securing the USB Device

    Use the screw torq to tighten the two front screws of the USB clamp. This will secure the USB device in place.

    [Diagram: Shows the USB device inserted into the SonicWave device and secured by the clamp. Arrows indicate tightening the front screws of the clamp.]

  5. 5 USB Device Secured

    The USB device is now securely attached to the SonicWave 432e/432i.

    [Diagram: Shows the final assembly with the USB device securely attached to the SonicWave 432e/432i via the USB security clamp.]

Safety and Regulatory Information

For safety, environmental, and regulatory information, refer to the documentation provided with the SonicWall appliance.

Legend

[Warning icon] WARNING: Indicates a potential for property damage, personal injury, or death.
[Caution icon] CAUTION: Indicates potential damage to hardware or loss of data if instructions are not followed.
[Information icon] IMPORTANT, NOTE, TIP, MOBILE, or VIDEO: Indicates supporting information.

Document: SonicWave 432e/432i USB Clamp Installation and Assembly Guide

Version: Updated - May 2020, Document ID: 232-005303-50 Rev A

Original Document

If the viewer doesn’t load, open the PDF directly.