DELTACO Mobile Sit-Stand Workstation

Product Overview

This document provides assembly instructions and usage guidelines for the DELTACO Mobile Sit-Stand Workstation, model DELO-0111. It is designed for ergonomic office environments, allowing users to adjust the workstation height between 758 mm and 1128 mm.

Specifications and Dimensions

The workstation features a desktop with dimensions of 600 mm (width) x 520 mm (depth) and a thickness of 16 mm. The main support column has a width of 70 mm. The base width is 566 mm, and the depth is 501 mm. The adjustable height range is from a minimum of 758 mm to a maximum of 1128 mm. The base height is 117 mm. The desktop can be tilted from 0° to -30°.

Parts List

• A (x1): Main support column
• B (x1): Base frame
• C (x1): Desktop
• D (x1): Lifting mechanism
• E (x2): Casters
• F (x2): Caster locks
• G (x4): M6x60 screws
• H (x4): M6x25 screws
• I (x4): M6x12 screws
• J (x4): Washers
• K (x1): 4mm Allen key
• L (x1): 5mm Allen key
• M (x1): Wrench

Assembly Instructions

Step 1: Assemble the Base and Lifting Mechanism

Attach the base frame (B) to the lifting mechanism (D) using the provided screws (likely G or H) and the wrench (M). Insert the caster wheels (E) into the designated sockets on the base frame (B). Attach the caster locks (F) to the appropriate locations on the base frame.

Step 2: Connect Support Column to Base

Attach the main support column (A) to the assembled base and lifting mechanism. Use screws (G) and washers (J) to secure the column to the base. The diagram shows the column (A) being attached to the base assembly, with screws (G) and washers (J) being used.

Step 3: Mount the Lifting Mechanism and Desktop

Attach the lifting mechanism (D) to the top of the support column (A). Connect the desktop (C) to the lifting mechanism (D) using screws (I) and the 4mm Allen key (K). The diagram shows the lifting mechanism (D) being mounted on the column, and then the desktop (C) being attached to the mechanism with screws (I) and the Allen key (K).

Step 4: Adjust Height

The workstation can be adjusted in height by operating a lever or pedal mechanism. The diagram illustrates using a foot to operate a lever, causing the workstation to move up or down.

Step 5: Adjust Desktop Tilt

The desktop can be tilted to an angle between 0° and -30°. A hand is shown operating a lever or mechanism on the side of the desktop to adjust its angle.

Important Safety and Usage Information

• Read the entire instruction manual before starting installation and assembly.
• Caution: Using the workstation with items heavier than the specified weight limit may cause instability and potential injury.
• Ensure the product is attached as specified in the assembly instructions. Improper installation can lead to serious injury.
• Use appropriate safety gear and tools. Installation should only be performed by a qualified person.
• Verify that the supporting surface can safely bear the combined weight of the workstation and all attached equipment.
• Use the provided mounting screws and do not overtighten them.
• This product contains small parts that could be a choking hazard if swallowed. Keep these items away from children.
• This product is intended for indoor use only. Outdoor use may lead to product failure or personal injury.
• Important: Ensure all parts are received according to the component checklist before installation. Contact Deltaco or your retailer if any parts are missing or faulty.
• Caution: Do not exceed the marked maximum weight. Serious injury or property damage may occur.
• Check regularly (at least every three months) that the product is securely fastened and safe to use.