User Manual

Layout

Waterproof Cover

USB-C Input/Output

USB-A Output

Solar Panel

Power Button

Solar Indicator Light (Green)

Capacity Indicator Light (Blue):

• ○○○○: 1%~25%
• ●○○○: 25%~50%
• ●●○○: 50%~75%
• ●●●○: 75%~100%

Micro USB Cable

Lightning Cable

LED Flashlight ((?))

Wireless Charging Pad ((⚡️))

Lanyard Hole

USB-A Cable

Type-C Cable

Specification

How to use the Flashlight?

Press and hold the power button for 3 seconds to turn the flashlight on or off. When the flashlight is on, short press to switch between strong-SOS-strobe-off.

Standard

SOS

Strobe

How to recharge the Solar Charger?

1. By USB Cable (Use PD/QC adapter to achieve faster charging).
2. By Built-in USB-A Cable
3. Solar Charging
   Put the Solar Charger outside in direct sunlight, the green light will turn on and the blue lights will flash to show that it's charging. Once all four lights are on, the charging is complete, and you can bring the solar charger inside. Remember to keep the port cover closed when charging outdoors.

Charge Your Phone or Tablet.

Micro

Type-C

Lightning

Wireless Charging Instructions

1. Press the power button to activate the wireless charging function, then place your phone on the wireless charging pad, ensuring that the center of the phone is aligned with the center of the wireless charging pad. This way, your phone will start charging within 2 seconds. If not, adjust the position of the phone.
2. The distance between the phone and the wireless charging pad must be less than 3 mm. If the phone case is too thick, it will affect the wireless charging function.
3. No metallic objects, such as metal phone cases, coins, metal plates, etc., should be placed between the device to be charged and the wireless charging pad.

Reminder

1. Fully charge the solar charger before first-time use.
2. When there is only one blue indicator light flashing, please stop charging your devices and recharge the solar charger as soon as possible.
3. When charging your phone, please use the original cable provided with your phone to ensure intelligent recognition and rapid charging.
4. To extend battery life, fully charge the unit with a wall charger every 3 months.
5. Avoid scratching the solar panels.
6. Solar charging speed is subject to sun intensity, temperature and weather conditions. Therefore, it is recommended to use it as a backup power source only.
7. Do not place the solar charger into fire or water.
8. It is normal for the solar charger to become slightly warm during charging or discharging.

WARNING

1. This product is not a toy, please keep it out of the reach of children to avoid accidents.
2. When charging the product outdoors using solar power, please bring it back inside after sunset. Humid weather at night may cause short circuits and battery failure.
3. The operating temperature of this product is 0°C~45°C (32°F~113°F). Please do not expose it to temperatures above 60°C (140°F), including areas near heat sources such as stoves or heaters.
4. This product contains a Li-polymer battery, so it is strictly prohibited to disassemble, squeeze, puncture, or expose it to water or fire, as it may damage the battery, cause short circuits, fires, or burning.
5. If there is bulging, deformation, liquid leakage, overheating, or significant power loss, please stop using it immediately, dispose of it properly, and contact us for a replacement or a full refund.

Federal Communications Commission (FCC) Statement. This device complies with part 15 of the FCC Rules. Operation is subject to the following twoconditions: (1)This device may not cause harmful interference, and (2)this device must acceptany interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide Reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: •Reorient or relocate the receiving antenna. •Increase the separation between the equipment and receiver. •Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. •Consult the dealer or an experienced radio/TV technician for help. Warning: Changes or modifications made to this device not expressly approved by Yuwei Technology (Dongguan) Co., Ltd. may void the FCC authorization to operate this device. Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user's authority to operate the equipment. RF exposure statement: This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. The device is installed and operated without restriction.