DieseRC 2201M Relay Remote Control Switch

Product Information

Type: 2201M

Wiring Diagram

Diagram A illustrates the connection of the smart switch to an AC power source (85V-250V) labeled L (Live) and N (Neutral). The switch's input terminals are connected to L and N. The output terminals of the switch are then connected to a light bulb, with the switch's output terminals controlling the power flow to the bulb.

Diagram B shows a similar wiring setup for the smart switch, indicating input connections for L and N and output connections for controlling a load.

Product Detail

The product features an "Indicator Light" and a "Learning Button".

Customer Service

If there are any questions about the products, please contact Huizhou Wenqiao Electronic Technology Co., Ltd. first. They will do their best to solve your problem.

Contact Information:

• WhatsApp: +86 135 0227 8583 / +86 181 3880 5271
• Email: dieseelectronic@163.com

This device is compatible with Directive 2014/53 EU Rules.

Documentation Links:

• Product Information Link 1
• Product Information Link 2

Manufacturer Address: Room 03, 12th Floor, Building T19, East Coast Garden, Fangzhilonghuwan, No. 27, Sanhuan South Road, Huicheng District, Huizhou City, Guangdong Province, China 516001

Usage Instructions

Notes on Wiring and Usage

• Be safe when wiring and always keep the power off.
• L (Live) and N (Neutral) lines cannot be reversed.
• When using wireless electronics, take care to avoid metal objects, large electronic devices, electromagnetic fields, and other sources of strong interference.
• Replace the battery in time when the wireless switch voltage is low to ensure stronger signal transmission.

How to Pair

1. Click the learning button (on the receiver) 2 times. The indicator LED on the receiver will light up.
2. Then click one button (on the wireless switch). The indicator on the receiver will flash several times and then turn off. Pairing is successful.

Note: If you have more than one wireless switch, you must set up each wireless switch individually by following the steps above.

Reset

Click the learning button 8 times (on the receiver). Reset is successful.

Notice: After reset, all wireless switches will no longer be able to control this receiver.

Troubleshooting

If the receiver and transmitter cannot operate normally, try to solve the problem by following the steps below:

1. Please check if the batteries are depleted. The indicator LED on the wireless switch does not light up or is dimly lit.
2. Please check if your receiver is wired correctly. It is important to ensure the wiring is correct.
3. Reprogram the receiver and wireless switch. This can usually solve many problems.
4. If the problem still remains, please contact customer service in time. They will do their best to solve your problem.

Contact: Email: dieseelectronic@163.com or WhatsApp: +86 13502278583