Product Information
| Description | Door Scuff Assembly |
|---|---|
| Application | ELANTRA N |
| Part number | IB858-AM000 |
| Parts supplied with | Door Scuff Assembly (2 pieces) |
| Tools required | Plastic trim remover |
Personal Protection Equipment
- ? Protective gloves
Important Notices
⚠️ Read this manual carefully.
⚠️ Warranty is void if not installed accordingly to this manual.
Installation Instructions
Notice: Procedure shown for RH side; LH side is identical.
Step 1: Detach Weather Strip
Image displays the interior of the front passenger door sill area. A label 'A' points to the lower section of the door's weather stripping, shown being detached from the vehicle body.
Instruction: Pull and detach the bottom portion of the front door body side weather strip (A).
Step 2: Remove Scuff Trim
Image displays the interior of the front door sill. The original door scuff trim is labeled 'A'. Red circles indicate clip locations. An inset diagram shows a plastic trim tool being used to release clips.
Instruction: Remove the front door scuff trim (A).
Step 3: Install Door Scuff Assembly
Image displays the interior of the front door sill with the original trim removed. The new N Performance door scuff assembly, labeled 'A', is positioned for installation.
Instruction: Install the door scuff assembly (A) on both sides.
Step 4: Reinstall Weather Strip
Image displays the interior of the front door sill with the new scuff assembly installed. The door's weather stripping, labeled 'A', is shown being reattached.
Instruction: Install the front door body side weather strip, ensuring it is properly aligned and securely attached.
FMVSS 110 Compliance Information
All dealers must determine if the weight they have added in the form of all options or accessories, when added to the weight of all Port/Dealer installed options or accessories, exceeds the lesser of 1.5% of GVWR or 100 lbs. If the additional weight does exceed the lesser of the indicated thresholds, a "Load Carrying Capacity Reduced" label must be installed. A black, fine-point, indelible marker must be used to write by hand onto the label the reduced carrying capacity in kilograms or pounds, which is the total weight of all added options and accessories.