KK Home G1 Gateway and Smart Plug

LED Indicator Status

How to connect to G1 Gateway

1. Step 1: Download KK Home App
   Scan the QR code to download the KK Home App from the App Store or Google Play.
   IMPORTANT:
   1. Only compatible with KK Home App.
   2. Please add the G1 gateway in the KK Home App, and then add the smart lock.
2. Step 2: Create an account for the App.
   If you are an existing user: You can integrate this device into your KK Home App for easy control. If you are a new user: Please click the “Sign Up” button to create your account.
   
   • Fill in your email ID
   • Enter the verification code received in your email inbox
   • Set up an account password
   • Create an account successfully
     
3. Step3：Add the G1
   1. Plug the G1 gateway into the socket.
      
   2. Open the App and scan the QR code on the device. IMPORTANT:
      Keep the G1 gateway within 49ft (15 meters) of your home router
   3. Press and hold the power button for 5 seconds until the indicator is flashing.
      
   4. Set up Wi-Fi connection, it only works with 2.4GHz Wi-Fi network.
      
4. Step4: Add the smart lock in the App.
   Please refer to the App guide for the smart lock. Note: Before adding a smart lock in the App, please make sure the G1 gateway has been added successfully.

Technical parameters

• Maximum current: 10A
• Rated voltage: 100-240V
• Rated power: 2200W
• Input voltage: 100-240V

IMPORTANT:
Keep the G1 gateway within 32ft (10 meters) of the door lock

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

RF Exposure Information
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.

ISED Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
This device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and  compliance with RSS 102 RF exposure, users can obtain Canadian information on RF exposure and compliance.
This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment.

Documents / Resources

KK Home G1 Gateway and Smart Plug [pdf] User Manual G1 Gateway and Smart Plug, G1, Gateway and Smart Plug, and Smart Plug, Smart Plug

References

• User Manual