Raspberry Pi A 3.5 Inch Display Module
Informasi produk
Spesifikasi:
- Power Supply: 5V 2.5A recommended
- Kompatibilitas: Raspberry Pi
- Resolution: Dependent on OS Image
- Driver Installation Required: Yes
Pandhuan Panggunaan Produk
Installing Driver and Setting Up Display:
- Download and unzip the OS Image you intend to use.
- Download and install Raspberry Pi image burn software.
- Use Raspberry Pi imager software to flash the OS Image with
pre-loaded LCD Driver to the SD card.
Cathetan: If you encounter difficulty with driver
installation or the display is not functioning correctly, try using
the Configned images provided for testing. Download and write the
image into the TF card without the need for any driver installation
langkah.
Tips:
- When using with the Raspberry Pi, ensure to install the driver
and write the code to avoid white screen display issues. - It is recommended to use a power supply above 5V 2.5A to
prevent startup failures leading to a white screen.
Pitakonan sing Sering Ditakoni (FAQ)
Q: What should I do if I encounter a white screen issue?
A: If you are facing a white screen problem,
try using the Raspbian Bullseye version as a last resort.
Fitur
320×480 resolution, LCD Interface: SPI(Fmax:32MHz) Resistive touch control, comes with touch pen Supports any revision of Raspberry Pi (directly-pluggable) Compatible with Raspberry Pi A, B, A+, B+, 2B, 3B, 3B+,4B, 5 versions Drivers provided (works with your own Raspbian/Ubuntu directly) GPIO physical interface, Size perfectly fits the Raspberry Pi Supports Raspbian system, ubuntu system ,kali Linux system
Langkah-langkah
Warm TipsIf you have difficulty installing the driver, or if you still can’t use the display properly after installing the driver, Please Try our Configned images for tested. Just need download and write the image into the TF card. DO NOT need any driver installation steps.
1. Download and unzip the OS Image you intend to use 2. Download and install Raspberry Pi image burn software 3. Use Raspberry Pi imager software to flash the OS lmage with pre-loadder LCD Driver to
the SD card If you still keep getting the white screen issue, try the Raspbian Bullseye version at last.
Tips
When using with the Raspberry Pi, you must first install the driver and write the code, otherwise the screen will only display white.
It is recommended to use a power supply above 5V 2.5A, otherwise it may fail to start and the screen will only display white.
Dokumen / Sumber Daya
 | AOKIN Raspberry Pi A 3.5 Inch Display Module [pdf] Manual Pamilik Raspberry Pi A 3.5 Inch Display Module, 3.5 Inch Display Module, Display Module, Module |