JBL LOGO

JBL Live Free 2 TWS Wireless Earphone

JBL Live Free 2 TWS Wireless Earphone

Charging

JBL Live Free 2 TWS Wireless Earphone FIG 1JBL Live Free 2 TWS Wireless Earphone FIG 2

Charging through A Qi-certified wireless charging pad (not included)

LED behaviors

JBL Live Free 2 TWS Wireless Earphone FIG 3

JBL Live Free 2 TWS Wireless Earphone FIG 4

TECH SPEC

  • Model: LIVE FREE 2 TWS
  • Driver size: 10 mm/ 0.4” Dynamic Driver
  • Power supply: 5 V 1 A
  • Earbud: 4.9 g per pc (9.8 g combined)/
  • 0.01 lbs per pc (0.02 lbs combined)
  • Charging case: 43.7 g/ 0.094 lbs
  • Earbud battery type: Lithium-ion Battery (45 mAh / 3.85 V)
  • Charging case battery type: Lithium-ion Battery (620 mAh / 3.8 V)
  • Charging time: 2 hrs from empty
  • Wireless charging time: 4 hrs from empty
  • Music play time with BT on
  • and ANC off up to 7 hrs
  • Music play time with BT on
  • and ANC on up to 6 hrs
  • Music play time with BT on
  • and True Adaptive ANC on Up to 5 hrs
  • Frequency response: 20 Hz – 20 kHz
  • Impedance: 32 ohm
  • Sensitivity: 97 dB [email protected] kHz
  • Maximum SPL: 94 dB
  • Microphone sensitivity: -38 dBV/[email protected] kHz
  • Bluetooth version: 5.2
  • Bluetooth profile version: A2DP V1.3, AVRCP V1.6, HFP V1.7
  • Bluetooth transmitter
  • frequency range: 2.4 GHz – 2.4835 GHz
  • Bluetooth transmitter
  • power: < 9 dBm EIRP
  • Bluetooth transmitter
  • modulation: GFSK, π/4 QPSK, 8DPSK
  • Maximum operation
  • temperature: 45 °C

IC RF Exposure Information and Statement

The SAR limit of Canada (C) is 1.6 W/kg averaged over one gram of tissue. Device types: (IC: 6132A-LFREETWS2) have also been tested against this SAR limit According to this standard, the highest SAR value reported during product certification for head use is 0.407W/Kg.
The device was tested for typical bodily operations where the product was kept 0 mm from the head. To maintain compliance with IC RF exposure requirements, use accessories that maintain a separation distance of 0mm between the user’s head and the back of the headset. The use of belt clips, holsters, and similar accessories shall not contain metal parts in its assembly. The use of accessories that do not meet these requirements may not comply with IC RF exposure requirements and should be avoided.

Head operation
The device was subjected to a typical head manipulation test. In order to comply with RF exposure requirements, a minimum separation distance of 0 cm must be maintained between the user’s ear and the product (including the antenna). Head exposure that does not meet these requirements may not meet RF exposure requirements and should be avoided. Use only the supplied or approved antenna.

WARNING
DO NOT ATTEMPT TO OPEN, SERVICE, OR DISASSEMBLE THE BATTERY | DO NOT SHORT CIRCUIT | MAY EXPLODE IF DISPOSED OF IN FIRE | RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE | DISPOSE OR RECYCLE USED BATTERIES ACCORDING TO THE INSTRUCTIONS

Bluetooth
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc., and any use of such marks by HARMAN International Industries, Incorporated is under license. Other trademarks and trade names are those of their respective owners.

Documents / Resources

JBL Live Free 2 TWS Wireless Earphone [pdf] User Guide
LFREETWS2, APILFREETWS2, Live Free 2 TWS, Wireless Earphone, Live Free 2 TWS Wireless Earphone

Leave a comment

Your email address will not be published.