ZigBee Smart plug
ユーザーマニュアル
製品紹介
デバイスの重量は1kg未満です。 設置高さは2m未満をお勧めします。
インストール手順
- 電源オフ
感電を避けるため、設置および修理の際には販売店または資格のある専門家にご相談ください。
- 配線手順
デバイスの電源を入れる前に、配線が正しいことを確認してください。
S1/S2 can connect with the rocker light switch, or it doesn’t connect. To ensure safety, do not connect the neutral wire and live wire to it.
仕様
製品タイプ | Zigbeeスマートプラグ |
入力 | 100-240VAC 50/60Hz |
出力 | 100-240VAC 50/60Hz |
Max.Load | 10A/13A/16A/20A |
ジグビー | IEEE 802.15.4 2.4GHZ |
材料 | PCボイス |
特徴
ZigBee plug is a smart Plug that adopts the ZigBee plug wireless protocol and connects to your internet through the ZigBee hub. You can turn on/off, schedule on/off, and share the device with your family to control together, and so on.
![]() | ![]() |
![]() | ![]() |
![]() |
The above functions are determined by the ZigBee Hub.
取扱説明書
- アプリをダウンロード
Please refer to the user guide of the hub to download the corresponding APP. below platforms are recommended:スマートシングス アマゾンアレクサ 色相 - ハブ接続
Set the hub according to the user guide.Support ZigBee plug hubs as follows:
エコースタジオ
Echo Plus(モデル:ZE39KL)
第2世代エコーショー(モデル:DW84JL)
第2世代エコープラス(モデル:L9D29R)
Samsung SmartThings ハブ
フィリップス ヒュー接続に失敗した場合は、ハブをスマートフォンに近づけて、もう一度お試しください。
- 電源オン
電源を入れた後、デバイスは最初の使用時にペアリングモードに入り、LED信号インジケータが点滅します。The device will exit the pairing mode if no next operation for a long time. If you enter again, please long-press the manual switch for 5s until the LED signal indicator flashes and release.
- Alexaに接続する
1. Power on the Plug
2. Ask, “Alexa, discover devices!
3. Plug ashes once it’s connected
4. Wait until Alexa finishes, check the new devices” First/Second….plug”
SmartThingsに接続する
- Power up the smart bulb, bulb breathe 3 times, and enter the configuration state.
- Open the SmartThings app, and click”+”, click “Device”, click “SmartThings”, click “Lighting”, click ” Smart Bulb”, click “Start”, click “Next”, click “Skip the step”, click “Done”
工場出荷時設定にリセット
Long-press the configuration button for 5s until the LED signal indicator flashes and release, then the reset is successful. The device enters spairing mode.
If you pair the device with the hub again, please reset the device to factory default.
中国製
ドキュメント / リソース
![]() | ZigBee ライトスイッチモジュール [pdf] ユーザーマニュアル ライトスイッチモジュール、スイッチモジュール、モジュール |