User Manual Q&AAnswer
Sep 06, 2025 - 09:46 PM
According to the user manual for the Flextool FDC-1M Dust Collector, here are the steps to replace the filter:
1. **Turn off the dust collector:** Before replacing the filter, make sure the dust collector is turned off and unplugged from the power source.
2. **Access the filter:** Locate the filter compartment on the dust collector. It is typically located near the motor section of the unit.
3. **Remove the old filter:** Carefully remove the old filter from the compartment. Dispose of the old filter properly according to local regulations.
4. **Install the new filter:** Take the new filter (FT100469-UNIT FLX DUST COLLECTOR FILTER H13) and place it into the filter compartment. Ensure it is securely in place.
5. **Secure the filter:** If there are any clips or fasteners to secure the filter in place, make sure to fasten them properly.
6. **Close the filter compartment:** Once the new filter is installed, close the filter compartment securely.
7. **Power on the dust collector:** Plug in the dust collector and turn it on to test the new filter.
By following these steps, you should be able to successfully replace the filter in your Flextool FDC-1M Dust Collector. If you encounter any difficulties or have further questions, refer to the user manual or contact Flextool customer support for assistance.
Add New Comment