IQUNIX ZX75 Series Mechanical Keyboard
LED Indicator Status Description
Indicator Location
Hold FN first, then the corresponding keys to enable special keys combination. Short Press: Hold FN first, then the corresponding key, and release both keys. Long Press: Hold FN first, then the corresponding key. Hold for 5 seconds until the indicator starts blinking.
Three Ways of Connecting Devices
Bluetooth Mode
- Toggle the keyboard Mode Switch to the wireless side.
- Short Press
then Long Press FN + to make the indicator blink in blue ,to make the indicator flash in blue. - Select the pairing device [QUNIX ZX75 BT 1]. The indicator turns off when the keyboard is paired successfully.
In order to complete the pairing of the keyboard with a second or third new Bluetooth device, repeat the instructions from Step 2 and replace the “FN+1” with “FN+2” or “FN+3”. The devices will be shown as [IQUNIX ZX75 BT 2] and [IQUNIX ZX75 BT 3].
2.4GHz Mode
- Toggle the keyboard Mode Switch to the wireless side. in
- Plug the 2.4GHz receiver into your computer.
- Press
to enter 2.4GHz connecting mode. The indicator turns off when the keyboard is connected successfully.
Wired Mode
- For Wireless Version, toggle the keyboard Mode Switch to the wired side.
- Plug the USB cable into your device.
- When being plugged into the computer, the keyboard will start to charge automatically.
- Caution: The rated power for the charger must not exceed 5V=14.
Connection to a higher power output will damage the keyboard.
Backlight Keys Combinations (Short Press)
Special Keys Combinations
Documents / Resources
 | IQUNIX ZX75 Series Mechanical Keyboard [pdf] User Manual ZX75 Series Mechanical Keyboard, ZX75 Series, Mechanical Keyboard, Keyboard |
