integratech RF RGBW Wall Mounted Controller Instruction Manual
Important: Read All Instructions Prior to Installation
Function introduction
Front Side
Back side
Product Data
| Output | RF signal |
| Operation Frequency | 869.5/434MHz |
| Power Supply | 3V(1xCR2430 battery) |
| Operating temperature | 0-40°C |
| Relative humidity | 8% to 80% |
| Dimensions | 86x86x14mm |
- Control 1 zone of receiver
- RGBW color controller
- Compatible with all universal series RF receivers
- 1 receiver can be paired by max 8 different remote controls.
- Waterproof grade: IP20
Safety & Warnings
- This device contains a button lithium battery that shall be stored and disposed properly.
- DO NOT expose the device to moisture
Pair with RF receiver
- Step 1:Do wiring the RF receiver according to wiring diagram(please refer to the instruction of RF receiver that you would like to pair with.
- Step 2:Click the “Learning Key” button on RF receiver or re-power on the receiver three times continuously to set it into pairing status.
- Step 3:Click any button on the remote(e.g. button ),LED lights connected with the RF receiver flicker once means the receiver is paired with the remote successfully.
Note: one receiver can be paired with max 8 remote controls.
Installation
The key part of this controller is a universal, extremely rotary standard switch element that can be integrated in numerous frames by different manufactures as below list.
| BEKER | S1, B1, B3, B7 glass |
| GIRA | Standard55, E2, Event, Esprit |
| JUNG | A500, Aplus |
| MERTEN | M-smart, M-Arc, M-Plan |
Built-in 10 color changing modes are as follows:
- Mode 1: Any two colors of RGB mix fade-in & fade-out
- Mode 2: RGB three colors mix fade-in & fade-out
- Mode 3: RGB three colors mix fade-out & fade-in
- Mode 4: RGB flash
- Mode 5: RGB three colors fade-in & fade-out successively
- Mode 6: RGB three colors fade-in successively
- Mode 7: RGB three colors fade-out successivel
- Mode 8: RGB three colors jump changing successively
- Mode 9: R&B two colors mix fade (R in B out), then G fade-in, then R&B mix fade (R out B in), then G fade-out
- Mode 10: B fade-out, then G&B mix fade (G out B in), then R&G mix fade (R out G in), then R fade-in.
Documents / Resources
 | integratech RF RGBW Wall Mounted Controller [pdf] Instruction Manual RF RGBW Wall Mounted Controller, RF Wall Mounted Controller, RGBW Wall Mounted Controller, Wall Mounted Controller, RGBW Controller |
