INSIGNIA NS-SCR115 75" Tripod Projector Screen Quick Setup Guide

Contents hide

1 INSIGNIA NS-SCR115 75″ Tripod Projector Screen Quick Setup Guide

3 References

4 Related Posts

INSIGNIA NS-SCR115 75″ Tripod Projector Screen Quick Setup Guide

PACKAGE CONTENTS

75″ Tripod Projector Screen
Quick Setup Guide

FEATURES

Durable, high-contrast material
Easy to operate

Before using your new product, please read
these instructions to prevent any damage

ITEM	DESCRIPTION
Screen hanger notch	Provides a notch to hang the projector screen.
Flip-lever center column lock	Locks or unlocks the first section of the tripod center column
Screen height handle	Hold this handle to raise or lower the center column.
Flip-lever for the screen height handle lock	Locks or unlocks to slide up or down the screen height handle.
Positioning pin release lever	Push this release lever to insert or release the positioning pin in the positioning hole.
Positioning hole	Attaches to the positioning pin on the back of the projector screen.
Tripod leg	Supports the tripod and projector screen.
Screen enclosure	Enclosure for the screen when not in use.
Projector screen hanging bracket	Hang the projector screen using this bracket.
Positioning pin	Position projector screen by inserting it into positioning hole.
Projector screen	Displays pictures from the projector.

USING YOUR TRIPOD PROJECTOR SCREEN

Open the three legs of the tripod and stand the tripod up.
Loosen the flip-lever center column lock, then raise the center column so
that the screen hanger notch is just below your eye-level (this position
makes it easier to attach the projector screen hanging bracket), then fasten
the flip-lever center column lock to secure the column in place.
Unlock the flip-lever for the screen height handle lock and slide the
screen height handle to approximately your waist-level (this position
makes it easier to attach the screen enclosure), then fasten the flip-lever
for the screen height handle to secure it in place.
While holding the screen enclosure, push the red positioning pin release
lever and insert the positioning pin into the positioning hole. When the pin
is fully inserted, the positioning pin release lever will spring back into its
non-released positioned.
Pull out the projector screen by pulling up on the projector screen hanging
bracket, then hang the projector screen hanging bracket on the screen
hanger notch on top of the center column.
From the back side of the screen you can now set the height of the screen.
You can set the height of the bottom edge of the screen by unlocking the
flip-lever for the screen height handle and changing the position of the
screen height handle. Change the height of the top edge of the screen by
unlocking the flip-lever center column lock, and raising the center column.
When not in use, remove the screen enclosure from the tripod by reversing
the installation steps.

REATTACHING THE SCREEN ENCLOSURE
You can reattach the screen enclosure to the disassembled tripod to
conveniently carry and store the projector screen when not in use.

Extend the center column completely, then position the screen enclosure
so that the hole in one end of the screen enclosure is on the same side as
the screen hanger notch on the center column.
Attach the screen enclosure positioning pin to the positioning hole. Once
this is done, the center column can be repositioned so that the pin below
the screen hanger notch inserts into the hole on the end of the screen
enclosure.

SPECIFICATIONS