INSIGNIA NS-MCRG6S9-2 2-Pack Silicone Seals for Insignia Pressure Cookers QUICK SETUP GUIDE

Insignia logo

2-Pack Silicone Seals for Insignia Pressure Cookers

If the seals inside your pressure cooker are damaged, have an odor, or do not create a tight seal, you need to replace the seals. Seals help maintain the correct pressure.


  • Silicone Seals (2)
  • Quick Setup Guide


  • Two swappable seals prevent savory and sweet odors from mixing
  • BPA free and FDA approved for safe contact with your food
  • Works with Insignia and select other pressure cookers with a 9-inch (22.8 cm) diameter


  1. Remove the old seal by carefully pulling it up section by section.replacing the seal
  2. Install the new seal by pressing it down section by section into the seal rack. You can install the seal with either side facing up.Install new seal
Before each use:
  • Make sure that the seal is well seated in the seal rack. If necessary, carefully shift the seal clockwise or counter-clockwise inside the seal rack to improve sealing.
  • Make sure that the anti-block shield is correctly mounted on the steam release pipe.
  • Do not use force when pulling the seal. Using force can cause deformation and lead to a poor seal between the lid and the cooker body.
  • Do not use a seal with cracks, cuts, or other damage.
  • Keep the seal clean to avoid odor. Wash the seal in warm soapy water or in a dishwasher to remove odor. If washing does not get rid of the odor, replace the seal.


Dimensions (H × W): 0.7 x 9.4 in. (1.8 x 23.8 cm)
Weight: 0.12 lbs. (55 g)


Visit for details.


For customer service, call 1-877-467-4289 (U.S. and Canada) or 01-800-926-3000 (Mexico)

INSIGNIA is a trademark of Best Buy and its affiliated companies Distributed by Best Buy Purchasing, LLC
7601 Penn Ave South, Richfield, MN 55423 U.S.A. ©2018 Best Buy. All rights reserved, Made in China

INSIGNIA NS-MCRG6S9-2 2-Pack Silicone Seals for Insignia Pressure Cookers QUICK SETUP GUIDE – Download

Leave a comment

Your email address will not be published. Required fields are marked *