Categories: Ikea

IKEA BEKANT Underframe Transformer for Table Top Instructions

IKEA BEKANT Underframe Transformer for Table Top Instructions

This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance.

Cleaning and user maintenance shall not be made by children without supervision.

Installation instructions

  • The table is assembled according to separate assembly instructions.
  • Connect the cable from one leg to the other. Connect the hand control to one of the leg and the power-supply to the other leg. The cables to the legs, hand control and power supply should be placed in the accompanying net. Place the electrical cables so that they do not get damaged, see assembly instruction.
  • Connect the electrical cable to a wall socket. NB! The electrical cable must have full mobility.
  • Insert the safety key in the socket on the hand control.
  • The table is now ready for use. The motors stop automatically when the table reaches its lowest and highest position respectively
Usage of the table
  • The table shall only be used as a working table with the possibility to continuously adjust working height between sitting and standing position. The table shall only be used indoors and in dry premises (office environment or similar).
  • The table must not be overloaded – maximum load is 70 kg/154 lbs. The motors may be run continuously for maximum 1 minutes. Afterward, the motors must stand by for approx. 9 minutes before they can be used again.

Follow these instructions when adjusting table height:

  1. Insert the safety key in the socket on the hand control.
  2. Make sure no objects are in the way of the table adjusting height freely.
  3. In order to run the table up/down, press the man oeuvre button with an arrow pointing up and down respectively.

Translated from the original instructions.

Advice and instructions for BEKANT sit/stand desk.

Sound level: lower than 55 dB(A)
Height setting interval: EU-version: 64-125 cm NA-version: 57,4-122,4
Maximum load: 70 kg
Temperature interval at usage: +5 up to +40 degrees C
Temperature interval at storage: -10 up to +50 degrees C
Humidity: 20% up to 80% at +30 degrees C.
Power supply unit: DC 25-35V, 240W
Manufacturer: ROL ERGO
Model: EA11022-350 or ASW0579-2902002W

This appliance shall only be used together with the included power supply unit.

Every person who is responsible for this table at installation or employment of the table in daily use or in service and repair work should carefully read these instructions. Keep these instructions close to your sit/stand table.

Safety regulations

  • When the table is run up/down, keep the necessary safety distance to avoid the risk to get squeezed between the moving table top and fixed objects in the surrounding area.
  • When the table is run up/down the user shall keep watch so that nobody is injured or no object is damaged. The table top must not bump into a fixed object so that the table is overturned. Always remove any office chair before the table is run up/down.
  • When the table is left unattended, the safety key must be removed from the hand control and placed out of reach of children.
  • The table tripod must not be altered or reconstructed in any way. In service and repair work of the table, the electrical cable must always be disconnected from the wall socket.
  • Alterations to the control box are absolutely forbidden!
  • The table must not be used as a hoisting device for persons.

Maintenance and repair instructions

  • After approx. 1 week of use, check that the screws are properly tightened.
  • If the table cannot be lowered or raised, check the connections between the legs and the wall socket and be sure the safety key is inserted in the hand control.
  • If any part of the electrical system is replaced, the electrical cable must first be disconnected from the wall socket. Replace the electrical part and then connect the electrical cable to the wall socket. The table is now ready for use.

If the table still does not work, please contact your nearest IKEA store or customer service.

EU Declaration of Conformity
EU Declaration of Conformity is included in the packaging as a separate document.

Manufacturer: IKEA of Sweden AB
Address: Box 702, SE-343 81 Älmhult, SWEDEN
Telephone no.: +46(0)476-648500



Importer (authorized by the manufacturer
organization): LLC “IKEA TORG”, bld. 1, microraion
IKEA, Khimki, Moscow region, 141400 Russia, tel.:
+7(495) 737-5301, fax: +7(495) 737-5324

Date of manufacture specified in the format
DD.MM.YY on the label or package

Made in Lithuania

Product service life: 10 years

Regarding the quality of IKEA products contact seller: LLC IKEA DOM, Russia, 141400, Moscow Region, Khimki, IKEA microdistrict, bldg. 1 – through the form on website, by phone 8 (800) 234-55-66 or to the IKEA Service department in any IKEA store.

 The crossed-out wheeled bin symbol indicates that the item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or land-fill and minimize any potential negative impact on human health and the environment. For more information, please contact your IKEA store.


Documents / Resources

IKEA BEKANT Underframe Transformer for Table Top [pdf] Instructions
BEKANT, Underframe Transformer for Table Top, BEKANT Underframe Transformer for Table Top



Recent Posts

AVENTICS ED02 EP Pressure Regulator Instruction Manual

ED02 EP Pressure Regulator Betriebsanleitung | Operating instructions | Notice d'instruction | Istruzioni per l'uso…

4 mins ago

Labnet C0060 Spectrafuge 6C Compact Research Centrifuge Instruction Manual

C0060 Spectrafuge 6C Compact Research Centrifuge Labnet SpectrafugeTM 6C Instruction Manual Catalog Numbers: C0060 C0060-230V…

8 mins ago

XZENT X-RVC290-MK2 Colour Backup Camera Instruction Manual

X-RVC290-MK2 Colour Backup Camera RCA / Cinch Video Signal (CVBS) Fuse 0.5 A Red: DC…

11 mins ago

AIR INNOVATIONS AI-4000 2-in-1 Table and Floor Fan User Manual

AI-4000 2-in-1 Table and Floor Fan Foldable Rechargeable Fan 2-in-1 Table & Floor Fan READ…

13 mins ago

INVENTUM MN255C Combi Magnetron Instruction Manual

MN255C Combi Magnetron MICROWAVE OVEN combi magnetron MN255C MN304C MN305C · gebruiksaanwijzing · instruction manual…

19 mins ago

INVENTUM MN238S Solo Magnetron Instruction Manual

MN238S Solo Magnetron MICROWAVE · MIKROWELLE · MICRO-ONDES solo magnetron MN238S · gebruiksaanwijzing · instruction…

21 mins ago