iGear Dynamo Wireless Bluetooth Speaker
SPECIFICATIONS
- Bluetooth version: 5.0
- Speaker driver unit size: 4 INCH
- Output power: 16W
- Frequency response: 100Hz-20KHz
- Signal-to-noise ratio: >8SdB
- FM scan range: 87.5-108.0Mhz
- Wireless range: 10 meter
- Max memory USB/SD: 32GB
- USB charging: DC SV
- Battery capacity: 1200mAh
- Playtime: Upto 4 hours at 50% Volume
- Charging via USB port (PC): 2-3 hours charging time
CONNECT TO BLUETOOTH DEVICE
- Turn on the iGear Dynamo.
- Switch ON your mobile device’s Bluetooth.
- search for the name “iGear Dynamo” and pair the device.
- Once the device is paired, Bluetooth will automatically connect when the unit is turned on.
TWS OPERATION
- Turn on both speakers at the same time.
- Choose one of them, on one of the speakers press and hold the “M” button for a few seconds, then a notification sound will indicate of pairing.
Note: TWS works in Bluetooth Mode only
INSTALLATION
- Digital Display
- TF Card slot
- Previous/Back Button
- Play/ Pause Button
- Forward/ Next Button
- Mode Button
- USB slot
- SV Charging Port
- AUX Port
- Mic Port
- Power (ON/ OFF) /Master volume knob
NOTE: If FM mode reception is not good, connect a Micro USB cable for better FM reception.
ACCESSORIES
- Charging cable: l piece
- Remote: l piece
- Corded Mic: l piece
- Aux cable: piece.
AUX-IN
To use AUX-IN, simply plug in the audio cable into the AUX jack, and press ‘M’ to switch to AUX-IN mode. You can long press
and
to turn down and turn up the volume. Please note that under AUX-IN mode, you will not be able to shift to Prev. and Next through the buttons on the Bluetooth speaker, it can be controlled by the connected devices.
USB/TF CARD
Insert the USB/TF card into the USB/TF slot. It will read the MP3 format music automatically. Press
to Play/Pause. Short Press or switch to Prev or Next Song. Long press or increase or decrease the volume.
FM RADIO
Long press the Play/Pause button, it will search for the available stations and save them automatically. Once the search is completed, Short press the button to switch between the saved stations. Long press or increase or decrease the volume.
CHARGING
Use the original charging cable to charge the device A Red LED lights up when the device is charging.
- Warranty period: l Year
- In case of consumer complaints: Toll-free number -1800 22 8495
- Email: sales@igear.asia (Between 10 am to 5 pm, Mon-Fri)
Documents / Resources
 | iGear Dynamo Wireless Bluetooth Speaker [pdf] User Manual Dynamo Wireless Bluetooth Speaker, Dynamo, Wireless Bluetooth Speaker, Bluetooth Speaker, Speaker |
