210629 Wi-Fi Ceiling Light with Docking
Scan for product info & manual
LET’S MEET ONLINE
Uw tablet of smartphone moet beschikking hebben over een 2.4GHz WiFi netwerk
Make sure that during the pairing process this device as well as your iOS or Android device will remain in the WiFi range of your router.
Replace LED module with qualified personnel only
If adding the device failed, it may be a networking problem. You can now proceed using the AP Mode for adding the device.
The bulb must blink slowly. If this is not the case you must reset the device by turning the bulb on/off/on/off/on/off/on.
Press ‘+’ and select ‘Lighting’ and choose the right luminaire.
Search the smart device name in the list of WiFi networks and connect. Devices will connect with each other.
Now open the Idinio Smart app again and wait until the connection process is finished.
Ensure you have fully read and understood the instructions in this document before you install or use the product following the installation/wire diagram (when applicable). Keep this document for future reference and only use the product as described in this document. Any other use of the product than described in this manual may damage the product or cause injury to the user (e.g. due to a short circuit, fire or electric shock). Disconnect the product from the power source if problems occur. Do not drop the product and avoid bumping. Do not use the product if a part is damaged or defective. Replace a damaged defective product immediately. When a non-standard consumer (power)installation is required this should be performed by a qualified technician to reduce the risk of an electric shock. Make sure the product is sufficiently ventilated during use. Never cover an electrical (LED) device during usage since it can generate heat causing damage. Besides LED can be extremely bright and may cause serious eye damage so don’t stare at it directly. When a product is meant for indoor and/or outdoor use only, this will be mentioned on the product/parts or in the manual. Keep the product out of reach of children or animals.
Cleaning and Maintenance Warning!
Do not use cleaning solvents or abrasives. Do not clean the inside of the device. Do not attempt to repair the device when the device does not operate correctly, replace it. Clean the outside of the device using a soft, damp cloth (don’t use a microfiber cloth).
If you need further help or have comments or suggestions please visit www.shada.nlinlkontact
Caution! Risk of electric shock.
This product contains a light source of energy efficiency class E
The item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or land-fill and minimize any potential negative impact on human health and the environment.
This product carries the CE mark, which confirms that this product meets EU safety, health, and environmental protection requirements.
The full text of the EU declaration of conformity is available at the following internet address: https://www.shada.nl/downloads.
Hierbij verklaard Shada dat 140148 WiFi Ceiling Light with Docking welke is voorzien van radioapparatuur voldoet aan richtlijn 2014/53/EU.
SHRDR Molenmakershoek 28, NL-7328 JK APELDOORN – The Netherlands
Documents / Resources
|idinio 210629 Wi-Fi Ceiling Light with Docking [pdf] User Guide|
210629 Wi-Fi Ceiling Light with Docking, 210629, Wi-Fi Ceiling Light with Docking