ICM CONTROLS Emerson 13.5 Relay Soft Starter
Product Information Emerson 13.5 Relay Soft Starter
The Emerson 13.5 Relay Soft Starter is an electrical component used to start and control the operation of a compressor. It has a legend that includes the following symbols:
- S: Start (Disconnected)
- C: Common
- H: Hermatic
- R: Run
- OL: Overload Switch
The product comes with the following wires:
- Black
- Brown
- Blue
- Red Start Capacitor
- White L1
- White L2
- C F Run Capacitor
- H3
- H2
- Relay
- White
- Orange
- Black OL C RS Compressor
Product Usage Instructions
- Step 1: Before servicing any electrical component, make sure to disconnect the power supply to avoid shock hazard.
- Step 2: Connect the wires to their corresponding symbols on the Emerson 13.5 Relay Soft Starter as per the legend mentioned above.
- Step 3: Splice the wires as needed. There are three 3-way spliced wires that should be connected together.|
- Step 4: Once all wires are connected, turn on the power supply to start the compressor. The overload switch (OL) will automatically turn off if the compressor experiences an overload.
Note: If you experience any issues with the Emerson 13.5 Relay Soft Starter, refer to the user manual or contact a certified technician for assistance.
WIRING DIAGRAM
CAUTION! SHOCK HAZARD!
Disconnect power supply before servicing any electrical component.
Documents / Resources
 | ICM CONTROLS Emerson 13.5 Relay Soft Starter [pdf] Instructions 13.5-Relay, Emerson 13.5 Relay Soft Starter, Soft Starter |