IBERA IB-QH2 Handlebar Bag Clamp
Instructions
Tools Required: 4 mm, 3 mm Allen keys.
Clamp Parts
- Large Allen bolts x 2,
- Washers x 2
- Sizing pins x 2
- Rubber shims x 2
- Nuts (embedded in clamp) x 2
- Brace blocks x 2
- Head stem brace wire
- Small Allen bolts x 2
Clamp
Adjust Clamp Size. Clamp arms have two sets of matching pin holes for smaller or larger diameter handlebars – default position suits most bars. To change setting, push pins out with 3 mm Allen key. Reinsert pin into lower holes.
Install clamp
Position clamp on middle of handlebars (around any E-bike display (monitor), facing front, button-side up (rubber shims should be flush with clamp arms and sit flat on handlebars).
Place washers over bolt holes in clamps. Insert brace block, large hole first. Align with bolt hole, insert large bolts – ensure clamp is horizontal. Tighten well with 4 mm Allen key. Thread brace wire through one of the small brace block side holes, under head stem, then through the second hole. With wire centered, pull it taut, then fasten small Allen bolts with 3 mm Allen key.
Attach Bag
Align fitting on rear of bag with clamp mount.
Push bag down, sliding it until it locks into mount. When bag is attached correctly, there should be a distinctive ‘click’ sound.
Detach Bag
Press button release while pulling bag upwards with strap at rear of bag.
Limited Warranty
Ibera warrants this product for normal usage against workmanship, and material defects to the original purchaser for two year from purchase date. Products purchased online are not covered by this warranty unless purchased from an authorized lbera online store.
- User assumes all risk of personal injury, damage to or failure of the product when it is used in jumping, acrobatics or similar activities.
- Warranty does not cover any incidental or consequential damages, such as personal injury or other losses due to accident, neglect, misuse, abuse, modification, normal wear and tear, improper care and cleaning, or failure to follow included instructions.
Warning
Ensure clamp is tight, and bag is secure before each ride. Do not use for off-road riding. Detach shoulder strap when riding.
See other Ibera products at www.ibera.info
Ibera Co. Ltd.
Specifications subject to change without notice. lbera is a trademark of lbera Co. Ltd. All other trademarks are property of their respective owners. Copyright lbera Co. Ltd. Made in Taiwan. Artwork: 07/20
Documents / Resources
 | IBERA IB-QH2 Handlebar Bag Clamp [pdf] Instructions IB-QH2 Handlebar Bag Clamp, IB-QH2, Handlebar Bag Clamp, Bag Clamp, Clamp |
