I-TECH COMPANY NPW9240K-TCB Remove and Replace AD board and Inverter
Model: NPW9240K-TCB
Instructions
(1) Before your work, please make sure that the power is disconnected.
Step 1: Remove all the LCD panel screws (14 screws) then remove the LCD cover.
Step 2: Remove the LCD mounting screws (8 screws, 3 on each side, 2 on top).
Step 3: Lift up the panel and disconnect the LVDS & inverter wire slowly and carefully for prevent the damage to both panel & wire, and remove the panel set out of its chassis.
Step 4: Remove these 4 screws to release the AD board.
Step 5: Flip over the AD board and disconnect all the connected wires, and then replace with new AD board.
~~~Follow the step backwrds to complete assembly the unit~~~
Documents / Resources
 | I-TECH COMPANY NPW9240K-TCB Remove and Replace AD board and Inverter [pdf] Instructions NPW9240K-TCB Remove and Replace AD board and Inverter, NPW9240K-TCB, Remove and Replace AD board and Inverter |
