HUBERT Automatic Soap Dispenser Stand User Manual

HUBERT Automatic Soap Dispenser Stand

Check all components

Part QTY
Soap dispenser 1
Base 1
Pole 3
Drip tray 1
Paper bill board 1
Black plate 1
Screw accessories 1bag
Key 1
Tableting 1
Step 1


There is a tabletting whcih above the stainless steel tube, rotate it 90 degress,
make it as·+· shape.

Step 2


There are 3parts of poles(up+mlddle+down), put a washer between each pole.connect them by fully lightened all the bolts.

Step 3

a close up of a logo
Make the screw hole end the tube aim at the screw hole on the platform, and insert the big steel plate.use the large hexagon screw fix It.

Step 4

diagram
Install the soap dispenser into the top of the stainless steel tube, aim at the screw hole on tab letting and use the screw fix It.

Step 5

a close up of a lift
Make the screw hole downside the billboard aim at the screw hole on the top of stainless steel back plane, use the tab letting and screw fix it.

 

 

 

 

 

 

 

 

 

Documents / Resources

HUBERT Automatic Soap Dispenser Stand [pdf] User Manual
HUBERT, pue 0104, Soap Dispenser Stand

Leave a comment

Your email address will not be published.