Milesight | 5G, AI, IoT and LoRaWAN®
User Guide for Milesight models including: SE0201-K-NX Camera 2MP 12X Pro Bullet Plus, SE0201-K-NX, Camera 2MP 12X Pro Bullet Plus, 12X Pro Bullet Plus, Pro Bullet Plus, Bullet Plus
QUICK START ... Step1: Using a cross screwdriver to remove the screws at the rear panel and side panel in an anticlockwise direction. 12. 13. 1 2. 13. Quick Start ...
prieš 22 valandas — QUICK START ... Step1: Using a cross screwdriver to remove the screws at the rear panel and side panel in an anticlockwise direction. 12. 13. 1 2. 13. Quick Start ...
File Info : application/pdf, 6 Pages, 18.54MB
DocumentDocumentQUICK START GUIDE SE0201-K/Nx Table of Contents 1.Package Contents........................................................................................................ 2 2.Hardware Introduction................................................................................................. 2 3.Interfaces.................................................................................................................. 3 4.Installation.......................................................................................................... 3 5.OpenVision Server Software Wizard......................................................................8 6.Ready to Start.........................................................................................................8 www.milesight.com 11 1. Packing List OpenVision Server x1 Quick Start Guide x1 Warranty Card x1 2.5" HDD Screw x8 3.5" HDD Screw x8 Mounting Bracket x2 Mounting Bracket Screw HDD Power Cable x4 x1 Power Cord x1 Power Adapter x1 2. Hardware Introduction SATA Cable x2 3.Interfaces REBOOT 12 3 456 7 8 9 10 1. Audio 2. 2*USB 3.0 3. 2*USB 2.0 4. HDMI Port 5. USB-C 6. DP Port and HDMI Port 7. 2*LAN Port 8. Power Port 9. Reboot Button 10. Power Button 4.Installation Step1: Using a cross screwdriver to remove the screws at the rear panel and side panel in an anticlockwise direction. 51.8mm 317.6mm 380mm 12 2 www.milesight.com www.milesight.com 3 13 Step2: Slide the upper casing to the rear first and lift it up. Step3: Secure the HDD from the bottom of the casing. 4 screws for each HDD. (3.5" HDD Installation) Step4: After that, check if all the screws are tightened. Then connect the power cable and data cable to each HDD. (2.5" HDD Installation) 14 www.milesight.com (Screw Position of 2.5" HDD) www.milesight.com 5 Step5: Pull down the upper casing and slide it to the front. (Screw Position of 3.5" HDD) Step6: Lock the screws on the rear panel and side panel. 16 www.milesight.com www.milesight.com 71 5. OpenVision Server Software Wizard Step 1: Prepare the monitor, mouse, and keyboard. Turn on the computer and enter the default Ubuntu password 1234 (the default username for Ubuntu is msadmin). Step2: Use the browser on the server itself to access 127.0.0.1:7001 to perform the initialization of the Nx server. If using another computer within the LAN, you can access it via the current server's IP address and port 7001. Get Started with Nx Witness Please configure the server first. Choose an option. Setup New System or Add to Existing System (if Nx Witness has been already setup) Note: By default, Nx Client is not pre-installed. Users can use Nx Client on another computer to configure and access the OpenVision Server. 6. Ready to Start When Machine is connected to a power source, it will power up automatically (Power up recovery is enabled by default). 18 www.milesight.com