Question: How Do I Clean My Humidifier? Answer: For routine cleaning and maintenance, select the appropriate cleaning video…
Your Enviracaire Elite™ HE225A and HE265A. Humidifiers from Honeywell are controlled by the H8908B Convertible Humidity Control. The convertible humidity control is installed either on an interior wall in the living area, or on the return air duct. Choose the humidity control setting using the combination relative humidity/outdoor temperature setting scale on your humidity control dial. Match the dial setting to the outdoor temperature for optimizing the humidity level while reducing moisture condensation on your windows. The table below can also be used to adjust humidity control to the recommended setting.
|At Outside Temperature||Recommended Control Setting||At Outside Temperature||Recommended Control Setting|
|-20°F (-29°C)||15||+10°F (-12°C)||30|
|-10°F (-23°C)||20||+20°F (-7°C)||35|
|0°F (-18°C)||25||Above 20°F (-7°C)||40|
As outside temperature drops, the recommended humidity control setting is lowered to adjust for effects of dewpoint. These settings should reduce the accumulation of moisture and ice on your windows and other areas of your home. Some indoor activities such as cooking, showering and clothes drying can cause excessive levels of humidity and start the accumulation of moisture on your windows. If this condition persists for more than a few hours, set the humidity control to the lowest setting to turn off the humidifier. If the condition does not improve, ventilate your home to remove the moisture.
Your Enviracaire Elite™ HE225B and HE265B. Humidifiers are controlled by the Honeywell H1008 Automatic Humidity Control with HumidiCalc+™. The automatic humidity control is mounted in the return air duct where it can be exposed to the air stream of the return air.
The HumidCalc+™ software inside your automatic humidity control is designed to measure or infer outdoor temperature and automatically adjust the humidity based on the frost factor setting that the homeowner sets to allow for variances in furnace size, window type and insulation.The Automatic Humidity Control with HumidiCalc+™ requires an initial adjustment period. For maximum humidification, set the H1008 to 10 and run the fan continuously. Check for condensation on windows after a cold night. If there is no condensation, leave the setting at 10. If there is condensation, lower the frost factor dial one setting. Continue to check for condensation on cold mornings until the correct humidity setting is reached for your home. Allow two days between adjustments to determine if further adjustment is necessary. Once you have tuned in the proper setting, you should never have to adjust it again. HumidiCalc+™ takes over and makes any future adjustments caused by varying outdoor temperatures, thus reducing moisture build-up on windows while maintaining the optimal humidity level.
|Humidity Level||Recommended Setting|
|Insufficient humidity||Increase the frost factor dial by one setting.|
|Condensation on windows||Decrease the frost factor dial by one setting.|
Your Enviracaire Elite™ humidifier uses the principle that vapor (evaporated water) is created when warm air blows over a water-soaked area. As the vapor circulates, the
relative humidity rises. Your humidity control monitors the relative humidity and activates the humidifier accordingly. The humidifier has a water supply that dispenses water evenly over the AgION™ antimicrobial humidifier pad. The warm dry air, from the furnace, passes over the humidifier pad and picks up the moist air to circulate it throughout your home. Humidified air feels warmer and more comfortable so you may be able to lower your thermostat heating setpoint, which saves money on your heating fuel bills. The end result is that your humidifier gives you a cleaner, more comfortable environment that is also energy efficient.
A regular maintenance program prolongs the life of your humidifier and provides a more comfortable home. The frequency of cleaning depends on the condition of your water. You can use either hard or soft water in your humidifier, but hard water mineral deposits are more difficult to clean than soft water deposits. For optimum performance, Honeywell recommends replacing the AgION™ antimicrobial pad once a year. Use the following procedure to clean your Honeywell humidifier.
IMPORTANT: Never oil any part of the humidifier.
Every 1 to 3 Months (Depending on Water Quality)
Clean the humidifier and shut it off at the end of the heating season. See Every 1 to 3 Months section, steps 1 through 15, to shut down for the season.
IMPORTANT:Be sure humidifier power is off.
After winter startup or servicing, check the humidifier operation:
|Problem||What to Look for||What to Do|
|Low humidity||Furnace blower not operating.||•Reset circuit breaker or replace fuse. |
•Check that the furnace power is on.
•Check all external wiring connections.
•Check humidity control setting.
•Call a heating contractor.
|Rapid air changes. Drafts (cold air is dry and is an added load to humidifier).||•Keep doors and windows closed. |
•Close fireplace damper if not using.
•Minimize exhaust fan running time.
•Seal around doors and windows.
|High humidity||Condensation on walls.||•Turn off humidity control and water until condensation is completely evaporated.|
|Heavy condensation on windows.||•Turn humidity control low enough to eliminate bath and cooking condensation moisture. If moisture persists, more ventilation is needed.|
ADDING PERFECT CLIMATE® CONTROLS FOR COMFORT AND CONVENIENCE
The cleanest, healthiest, most convenient, energy efficient, and comfortable indoor environment possible today! Perfect climate is achieved when the following five core components of a home’s climate system work together:
Contact your local Perfect Climate® dealer for an evaluation of your home.
Honeywell warrants this product, excluding the humidifier pad, to be free from defects in the workmanship or materials, under normal use and service, for a period of one (1) year from the date of purchase by the consumer. If, at any time during the warranty period, the product is defective or malfunctions, Honeywell shall repair or replace it (at Honeywell’s option) within a reasonable period of time. If the product is defective, return it, with a bill of sale or other dated proof of purchase, to the place where you purchased it.
This warranty does not cover removal or reinstallation costs. This warranty shall not apply if it is shown by Honeywell that the defect or malfunction was caused by damage
that occurred while the product was in the possession of a consumer. Honeywell’s sole responsibility shall be to repair or replace the product within the terms stated above.
HONEYWELL SHALL NOT BE LIABLE FOR ANY LOSS OR DAMAGE OF ANY KIND, INCLUDING ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING, DIRECTLY OR INDIRECTLY, FROM ANY BREACH OF ANY WARRANTY, EXPRESS OR IMPLIED, OR ANY OTHER FAILURE OF THIS PRODUCT. Some states do not allow the exclusion or limitation of incidental or consequential damages, so this limitation may not apply to you.
THIS WARRANTY IS THE ONLY EXPRESS WARRANTY HONEYWELL MAKES THIS PRODUCT. THE DURATION OF ANY IMPLIED WARRANTIES, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED TO THE ONE YEAR DURATION OF THIS WARRANTY. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. This warranty gives you specific legal rights, and you may have other rights which vary from state to state. If you have any questions concerning this warranty, please write Honeywell
Automation and Control Solutions
|Honeywell HE225A Bypass Flow-Through Humidifiers with Agion [pdf] Owner's Manual|
HE225A, HE225B, HE265A, HE265B, Bypass Flow-Through Humidifiers with Agion, HE225A Bypass Flow-Through Humidifiers with Agion
CX523PO Stand Alone Wood/Charcoal Grill Garden Outdoor Pizza Ovan Instruction Warnings-caution! This product is intended…
76986LO Candle Battery Operated Christmas Decor Lantern Model No. 76986LO Lowe's Item No. 2127390 Remove"TRY-ME"…
MTE380 Electric tiller Art.Nr. 5912312901 AusgabeNr. 5912312901_01 Rev.Nr. 30/06/2021 MTE380 DE Elektro-Motorhacke Originalbedienungsanleitung GB Electric…
MZJ-01 Immersion Circulator Precision Cooler