Honeywell 924CE Series 924CE55 Micro Switch Instruction Manual

WARNING

IMPROPER  INSTALLATION
  • Consult with local safety agencies and their requirements when designing a machine-control link, interface, and all control elements that affect
  • Strictly adhere to all installation

Failure to comply with these instructions could result in death or serious injury.

MOUNT, WIRE AND SEAL SWITCH

  1. Refer to Figures 1-4 on Page 3 for proper application of limit switches.
  2. Mount switch using two M5 or #10 screws. Torque screws to 5-6 N m (45-53 in lb).
  3. Wire standard units according to wiring diagram shown on switch cover nameplate.
  4.  Secure cable approximately 6 mm (0.25 in) from the point where the cable exits the switch housing in order to prevent ndue stress to cable sealing.

MICRO SWITCH MINIATURE ENCLOSED LIMIT SWITCH 24CE/924CE SERIES

Designation and Utilization Category Rated Operational Current Ie (A) at Rated Operational Voltage Ue (V) VA Rating
    120 V 240 V Make Break
AC15 B300 3 A 1,5 A 3600 360
DC13 R300 0,22 A 0,1 A 28 28
Rated Thermal Current (Ith) 10 A
Rated Impulse Withstand (Uimp) 2500 Vdc
Maximum Fuse Rating 10 A quick acting
Sealing IP66/IP67 on 24CE; NEMA 1, 3, 4, 12, 13 on 924CE
Operating Temperature Range 24 CE: 0 °C to 70 °C [32 °F to 160 °F]; 924CE: 0 °C to 105 °C [32 °F to 221 °F]
Complies with: •  Low Voltage Directive

•  EN 60947-5-1

MCTF (Mechanical Life): >1,000,000 cycles with single-sided confidence limit of 100 % MCTF (Electrical Life): > 25,000 cycles with single-sided confidence limit of 75 % Highest SIL Capability: SIL3 (HFT:1), IEC 61508-2

Proof Test Interval: 1 Year

ANGULAR TRAVEL (°) RECORRIDO ANGULAR (°) WINKELWEG (°)
COURSE ANGULAIRE (°) CORSA ANGOLARE (°) PERCURSO ANGULAR (°)
CAT FP OP1 OP2 PO1 MOF @ 38,1 mm [1.5 in]
24CE16-Y 0,0 30,0 50 7,85 N [1.77 lb]
924CE16-Y 0,0 26,0 50 7,85 N [1.77 lb]
24CE16-S 0,0 26,0 51 ±7 50 7,85 N [1.77 lb]
924CE16-S 0,0 26,0 51 ±7 50 7,85 N [1.77 lb]
24CE16-T 0,0 55 ±6 48,0 65 7,85 N [1.77 lb]
924CE16-T 0,0 55 ±6 48,0 65 7,85 N [1.77 lb]
VERTICAL TRAVEL (MM) RECORRIDO VERTICAL (MM) VERTIKALER LAUFWEG (MM)
COURSE VERTICALE (MM) CORSA VERTICALE (MM) PERCURSO VERTICAL (MM)
CAT FP OP1 OP2 PO1 MOF @ 38,1 mm [1.5 in]
24CE1-Y 17,1 14,9 13,1 22,5 N [5.06 lb]
924CE1-Y 17,1 14,9 13,1 22,5 N [5.06 lb]
24CE1-S 17,1 14,9 12,9 13,1 22,5 N [5.06 lb]
924CE1-S 17,1 14,9 12,9 13,1 22,5 N [5.06 lb]
24CE1-T 17,1 12,4 13,1 11,5 22,5 N [5.06 lb]
924CE1-T 17,1 12,4 13,1 11,5 22,5 N [5.06 lb]
24CE2-Y 29,9 27,7 25,9 22,5 N [5.06 lb]
924CE2-Y 29,9 27,7 25,9 22,5 N [5.06 lb]
24CE2-Sw 29,9 27,7 25,7 25,9 22,5 N [5.06 lb]
924CE2-S 29,9 27,7 25,7 25,9 22,5 N [5.06 lb]
24CE2-T 29,9 25,2 25,9 24,3 22,5 N [5.06 lb]
924CE2-T 29,9 25,2 25,9 24,3 22,5 N [5.06 lb]
24CE3-Y 29,9 27,7 25,9 22,5 N [5.06 lb]
924CE3-Y 29,9 27,7 25,9 22,5 N [5.06 lb]
24CE3-S 29,9 27,7 25,7 25,9 22,5 N [5.06 lb]
924CE3-S 29,9 27,7 25,7 25,9 22,5 N [5.06 lb]
24CE3-T 29,9 25,2 25,9 24,3 22,5 N [5.06 lb]
924CE3-T 29,9 25,2 25,9 24,3 22,5 N [5.06 lb]
24CE18-Y 23,9 21,7 19,9 22,5 N [5.06 lb]
924CE18-Y 23,9 21,7 19,9 22,5 N [5.06 lb]
24CE18-S 23,9 21,7 19,7 19,9 22,5 N [5.06 lb]
924CE18-S 23,9 21,7 19,7 19,9 22,5 N [5.06 lb]
24CE18-T 23,9 19,2 19,9 18,3 22,5 N [5.06 lb]
924CE18-T 23,9 19,2 19,9 18,3 22,5 N [5.06 lb]
24CE28-Y 43,9 41,7 39,9 22,5 N [5.06 lb]
924CE28-Y 43,9 41,7 39,9 22,5 N [5.06 lb]
24CE28-S 43,9 41,7 39,7 39,9 22,5 N [5.06 lb]
924CE28-S 43,9 41,7 39,7 39,9 22,5 N [5.06 lb]
24CE28-T 43,9 39,2 39,9 38,3 22,5 N [5.06 lb]
924CE28-T 43,9 39,2 39,9 38,3 22,5 N [5.06 lb]
24CE29-Y 43,9 41,7 39,9 22,5 N [5.06 lb]
924CE29-Y 43,9 41,7 39,9 22,5 N [5.06 lb]
24CE29-S 43,9 41,7 39,7 39,9 22,5 N [5.06 lb]
924CE29-S 43,9 41,7 39,7 39,9 22,5 N [5.06 lb]
24CE29-T 43,9 39,2 39,9 38,3 22,5 N [5.06 lb]
924CE29-T 43,9 39,2 39,9 38,3 22,5 N [5.06 lb]
24CE31-Y 35,7 33,5 31,7 25,5 N [5.74 lb]
924CE31-Y 35,7 33,5 31,7 25,5 N [5.74 lb]
24CE31-S 35,7 33,5 31,5 31,7 25,5 N [5.74 lb]
924CE31-S 35,7 33,5 31,5 31,7 25,5 N [5.74 lb]
24CE31-T 35,7 31,0 31,7 30,1 25,5 N [5.74 lb]
924CE31-T 35,7 31,0 31,7 30,1 25,5 N [5.74 lb]
24CE55-Y 35,7 33,5 31,7 25,5 N [5.74 lb]
924CE55-Y 35,7 33,5 31,7 25,5 N [5.74 lb]
24CE55-S 35,7 33,5 31,5 31,7 25,5 N [5.74 lb]
924CE55-S 35,7 33,5 31,5 31,7 25,5 N [5.74 lb]
24CE55-T 35,7 31,0 31,7 30,1 25,5 N [5.74 lb]
924CE55-T 35,7 31,0 31,7 30,1 25,5 N [5.74 lb]
24CE66-Y 32,0 29,8 28 25,5 N [5.74 lb]
24CE66-S 32,0 29,8 27,8 28 25,5 N [5.74 lb]
24CE66-T 32,0 27,3 28,0 26,4 25,5 N [5.74 lb]

MICRO SWITCH MINIATURE ENCLOSED LIMIT SWITCH 24CE/924CE SERIES

imensions in mm/inches

WARRANTY/REMEDY

Honeywell warrants goods of its manufacture as being free of defec- tive materials and faulty workmanship. Contact your local sales office for warranty information. If warranted goods are returned to Honeywell during the period of coverage, Honeywell will repair or replace without charge those items it finds defective. The foregoing is Buyer’s sole remedy and is in lieu of all other warranties, expressed or implied, including those of merchantability and fitness for a particular purpose.
Specifications may change without notice. The information we sup- ply is believed to be accurate and reliable as of this printing. However, we assume no responsibility for its use.
While we provide application assistance personally, through our literature and the Honeywell web site, it is up to the customer to deter- mine the suitability of the product in the application.

FOR MORE INFORMATION

Honeywell Safety and Productivity Solutions services its customers through a worldwide network of sales offices and distributors. For application assistance, current specifications, pricing or the nearest
Authorized Distributor,

USA/Canada +1 302 613 4491
Latin America +1 305 805 8188
Europe +44 1344 238258
Japan +81 (0) 3-6730-7152
Singapore +65 6355 2828
Greater China +86 4006396841

Honeywell

Advanced Sensing Technologies 830 East Arapaho Road Richardson, TX 75081 sps.honeywell.com/ast

 

Read More About This Manual & Download PDF:

Documents / Resources

Honeywell 924CE Series 924CE55 Micro Switch [pdf] Instruction Manual
924CE Series, 924CE55, 24CE Series, Micro Switch

References

Leave a comment

Your email address will not be published. Required fields are marked *