Hunter Irrigation Sprinkler Systems | Hunter Industries
Installation Guide for Hunter models including: ST-IBS-1700 Infill Barrier System, ST-IBS-1700, Infill Barrier System, Barrier System
2023-01-25 — Fit and Finish. After installation for non-infill type material or to create a smoother transition to the playing field, follow these additional steps.
File Info : application/pdf, 2 Pages, 292.45KB
DocumentDocumentINFILL BARRIER SYSTEM INSTALLATION GUIDE FOR THE ST-IBS-1700 NOTE Do not apply adhesive to the Hunter ST Infill Barrier System when installing the rotor. All parts must remain removable to allow for rotor servicing. 1. To install the ring of the rotor flange, use your fingers to pull and place each retaining segment of the ring under the flange. 2. After all retaining segments have been positioned, check to make sure they are completely under the rotor's flange. 3. To install the cup over the rotor's green logo cap, lift the logo cap and insert a piece of wood underneath. 4. Place the cup over the edge of the logo cap. 5. Use your fingers to pull and place each retaining segment of the cup under the logo cap's outer edge. hunterindustries.com ST-IBS-1700 Installation Guide 6. After all retaining segments have been positioned, recheck to make sure they are completely under the logo cap. 7. Carefully lower the logo cap and cup assembly. Take care not to disengage the cup from the logo cap. Make sure the cup and ring are aligned. 8. After the ring and cup are installed, unscrew the two screws on both ends of the actuator cover. 9. Push and slide the TTS insert over the actuator cover. Be sure the groove from the TTS insert slides into the gap on the ring. 9. (continued) 10. After the TTS Insert is installed, secure it using the supplied screws. Press the black plugs down to cover the screw openings. Fit and Finish After installation for non-infill type material or to create a smoother transition to the playing field, follow these additional steps. 1. Use a sharp blade or shears to trim/remove the infill barrier vertical walls. 2. Cut a round 30 cm diameter piece of the synthetic material being used for the project. 3. Use a Hunter-approved adhesive (ST-ADH-K) to attach it to the Infill Barrier System. 4. Do the same for the TTS insert, cutting a piece of the synthetic material to match its shape and securing it with the adhesive. HUNTER INDUSTRIES | Built on Innovation® 1940 Diamond Street, San Marcos, CA 92078 USA hunterindustries.com © 2022 Hunter IndustriesTM. Hunter, the Hunter logo, and all other trademarks are property of Hunter Industries, registered in the U.S. and other countries. RC-125 IG EM 10/22