User Guide for WYZE models including: WVODB1, 2AUIUWVODB1, WVOD1B1 Wireless Outdoor Security Camera, Wireless Outdoor Security Camera
Wyze Labs, Inc. WVODB1 BASE STATION 2AUIUWVODB1 2AUIUWVODB1 wvodb1
Front LIGHT INDICATIONS Base Station Solid yellow light The device is powered on and initializing Flashing blue light The device is connecting to the network Solid blue light The device is working properly Flashing yellow & blue lights The device is pairing with camera Wyze Cam Outdoor Solid yellow light The device is powered on and initializing Flashing blue light The device is connecting network Solid blue light The device is working properly Flashing yellow & blue lights The device is pairing with base station Flashing red light The device is charging Solid red light The device is fully charged No indicator light The device is powered off or sleeping Precautions: Using the camera in the car under direct sun exposure could exceed the operating temperature of the battery, resulting in irreversible damage to the battery. FCC Warning: This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any inte rference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. ·Increase the separation between the equipment and receiver. ·Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ·Consult the dealer or an experienced radio/TV technician for help. Radiation Exposure Statement To comply with FCC RF exposure compliance requirements, this grant is applicable to only mobile configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20cm from all persons and must not be colocated or operating in conjunction with any other antenna or transmitter. ISEDC RSS warning : This device complies with ISEDC licence-exempt RSS standard (s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'ISEDC applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. ISEDC Radiation Exposure Statement: This equipment complies with ISEDC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with minimum distance 20cm between the radiator& your body. Cet appareil estconforme aux limitesd'exposition de rayonnement RF ISEDC établiespour un environnement non contrôlé. Cetémetteur ne doit pas être co-implanté oufonctionner en conjonction avec toute autreantenne ou transmetteur. Industrial cellular router doit être installé et utiliséavec une distance minimale de 20cm entre leradiateur & votre corps. NEED HELP? Tutorial Videos www.youtube.com/wyzelabs Troubleshooting & FAQs support.wyze.com Community forums.wyze.com Contact Us support@wyzecam.com 1-844-WYZECAM CAM OUTDOOR QUICK START GUIDE Back SETUP 1 Download the Wyze app and create an account. 2 Follow the Wyze app to set up base station 3 Follow the Wyze app to set up the camera. 4 Follow the Wyze app to mount the camera. 1 2 SYNC Micro SD RIGHT 1 2 3 RESET 4 LEFT 3 5 OPEN 6 4 FRONT BACK 1 SYNC Button Power LAN 5 2 MicroSD Slot (MicroSD not included) 6 3 Reset BACK 4 USB Charging port 5 Power Input 6 LAN Port 7 Status Light 7 TOP SURFACE 7 SYNC Micro SD 8 1 Light Sensor 2 Lens 3 Microphone BOTTOM Removable Magnetic 4 Mounting Base 5 On-Off Switch USB Charging Port 6 Status Light 9 7 SYNC Button 10 MicroSD Slot 8 (SD card not included) Removable Magnetic Mounting Base 9 Wall Mounting Hole 10 Ceiling Mounting Hole Power Adapter USB Cable Ethernet Cable Screw Assembly IN THE BOX Wyze Cam Outdoor x1 Base Station x1 Base Station Power Adapter x1 Base Station Ethernet Cable x1 Camera Charging USB Cable x1 Quick Start Guide x1 Screw Assembly x1 Wall Mounting Ceiling MountingAdobe Illustrator CC 22.1 (Windows) Adobe PDF library 15.00