Instruction Manual

Ice Maker

Contact: service.wowowo@gmail.com

Page Content

• Important Safety Information
• Product Introduction
• Control Panel Introduction
• Using Your Ice Maker
• Cleaning and Maintenance
• Product Specifications
• Troubleshooting
• Short and Long-Term Warranty Information

Important Safety Information

To reduce the risk of injury or property damage, follow these safety precautions.

WARNING

• Voltage power from outlet must match specifications on appliance nameplate.

• This appliance must be grounded. ?

• Using an extension cord may cause overheating and increase the risk of fire.

  If an extension cord MUST be used:

  1. Only use an extension cord with grounding plug.
  2. The marked rating of an extension cord must be equal to or greater than the rating of this appliance.

• Do not operate if any component, including the cord or plug, is damaged. ❌

• Unplug the unit before cleaning by hand. ?️

• Only responsible and capable adults should operate the ice maker. ?‍⚖️

• Do not place the power cord where it could be pulled by children or pose a tripping hazard. ?

• Children should not be left unattended near the ice maker during operation. ?

• Do not use water that is micro-biologically unsafe or of unknown quality. ?

• Do not remove any safety, warning, or product information labels from the unit. ?️

• Do not touch the evaporator with your hands while the ice maker is operating. ?

• Do not plug in or unplug the unit with wet hands. ?

• The unit must be placed and set up according to installation instructions before use. The unit is for indoor household use only. ?

• Do not store or use flammable vapors or liquids near the unit. ?

• Do not immerse any part of the unit in water. ?

• Do not attempt to disassemble, repair, modify or replace any part of the ice maker without permission. ?️

WARNING

FIRE OR EXPLOSION HAZARD Flammable Refrigerant

This unit contains an isobutane refrigerant, also known as R600a, a natural gas with high environmental compatibility. However, it is also combustible. Adhere to the warnings below to reduce the risk of injury or property damage.

1. When handling, installing, and operating the unit, care should be taken to avoid damage to the refrigerant tubing. ⚠️
2. Only dispose of the unit according to Federal and Local Regulations. Contact your local authorities for the environmentally safe disposal of the unit. ♻️
3. Keep ventilation openings around the unit's enclosure clear of obstruction. ?
4. Do not place the unit near heat sources such as an oven. ♨️
5. Ensure a minimum of three inches of clearance around the side and back walls of the unit for proper air circulation. ?
6. Do not place the unit in direct sunlight. ☀️

Product Introduction

Tip: To pull off the cover, place your fingers in the opening under the left side.

Diagram Description: An illustration shows the ice maker with various parts labeled numerically. The main unit shows a removable top cover, control panel, water reservoir, ice outlet, and air exhaust fan. Separate components include a secondary water reservoir, ice full sensor, drain plug, maximum water fill line, filter, ice basket, and ice scoop.

Labeled Parts:

• 1. Removable Top Cover
• 2. Secondary Water Reservoir
• 3. Ice Full Sensor
• 4. Ice Outlet
• 5. Water Reservoir
• 6. Control Panel
• 7. Air Exhaust Fan
• 8. Drain Plug
• 9. Maximum Water Fill Line
• 10. Filter
• 11. Ice Basket
• 12. Ice Scoop

Control Panel Introduction

Diagram Description: An illustration of the ice maker's control panel with three indicator lights and a central button.

Using Your Ice Maker

Before First Use

1. Stand upright for 24hrs. Check for accessories.
   Diagram Description: An image shows the ice maker standing upright for 24 hours, next to an image of a checklist and accessories. A separate image shows a customer service icon with the text "Customer Service".
2. Use in locations 10°C ~ 32°C.
   Diagram Description: An illustration of a thermometer showing a temperature range from 10°C to 32°C, next to an illustration of ice cubes with the text "More Cycles = Perfect Shape".
3. What Not To Do!
   
   • Unstable base. ❌
   • No other liquids (Drinking water only). ❌
   • Do not use in high or low temps. ❌ (lower than 41°F/5°C)

How to Use Your Ice Maker

Do not put your fingers into the ice outlet. The ice maker will detect ice is full and stop working. Wait 3 mins before further operation. ⚠️

1. Open cover and remove basket.
   Diagram Description: An illustration shows the ice maker's top cover being opened and the ice basket being removed.
2. Pour water, do not exceed the "MAX" water mark.
   Diagram Description: An illustration shows water being poured into the ice maker's reservoir, with a "MAX" line indicated.
3. Press the “ICE/CLEAN” button.
   Diagram Description: An illustration shows a finger pressing the "ICE/CLEAN" button on the control panel.
4. Wait 6min-8min. (Depending on room temp and water temp)
   Diagram Description: An illustration of a clock showing a time range of 6-8 minutes.

Ice full and ready when “ICE FULL” indicator is on.
Diagram Description: An illustration of the control panel showing the "ICE FULL" indicator light on, with the text "Done".

When "ADD WATER” indicator is red, add water and press “ICE/ CLEAN”.
Diagram Description: An illustration of the control panel showing the "ADD WATER" indicator light red, with the text "Refill".

Cleaning and Maintenance

To keep your ice tasting fresh and the unit looking great, it is recommended to clean the unit once per week.

Manual Cleaning

1. Remove the top cover and basket.
   Diagram Description: Illustration showing the removal of the top cover and ice basket.
2. Clean both water reservoirs using a soft cloth dampened with warm water and vinegar, then rinse with clean water.
   Diagram Description: Illustration showing the cleaning of the water reservoirs with a cloth and solution.
3. Drain Plug. Drain excess water over sink.
   Diagram Description: Illustration showing the drain plug being opened to drain water, with a measurement of 60mm clearance indicated for a working table.
4. Clean exterior with cloth and mild dishwashing soap.
   Diagram Description: Illustration showing the exterior of the ice maker being cleaned.

Self-Cleaning (15-Min Process)

1. Remove the basket and add water up to the "MAX" water level.
   Diagram Description: Illustration showing the ice basket removed and water being added to the "MAX" level.
2. In Standby Mode: Hold for 5 sec to start self-cleaning.
   Diagram Description: Illustration of the control panel with a finger pressing and holding the "ICE/CLEAN" button for 5 seconds.
3. Drain Plug. Drain excess water over sink.
   Diagram Description: Illustration showing the drain plug being opened to drain water, with a measurement of 60mm clearance indicated for a working table.
4. Clean exterior with cloth and mild dishwashing soap.
   Diagram Description: Illustration showing the exterior of the ice maker being cleaned.

Do's & Don'ts while cleaning and maintaining:

• Do not use organic solvent, boiled water, detergent, strong acid and strong alkali etc. for cleaning. ❌
• When the unit is not to be used for a long duration, drain the water completely & dry the interior. ?➡️?
• Store in a well ventilated area. ?️

Product Specifications

Troubleshooting

Short and Long-Term Warranty Information

30-Day Limited Warranty

To provide customers with a quality shopping and user experience, the unit can be replaced or returned for a full refund within the 30-day period from the date of purchase.

30-Day to 1-Year Limited Warranty

After the 30-day warranty has expired, a 1-year warranty from the date of purchase that covers product replacement is automatically activated. Please note that proof of purchase is required for all warranty claims.

30-Day to 1-Year Warranty Limitations

This warranty does not cover:

• Any condition resulting from incorrect or inadequate maintenance or care.
• Damage resulting from misuse, abuse, negligence, accidents, or shipping damage.
• Dissatisfaction due to buyer's remorse.
• Normal wear and tear.
• Damages incurred after initial transportation.

Document Revision: 860-00640-00 Rev01