Instruction Manual for Zgonic North America models including: 300215, 2A3PG-300215, 2A3PG300215, 300215 Zview Wireless Charger, Zview Wireless Charger
Zgonic North America LLC 300215 2A3PG-300215 2A3PG300215 300215
SPECIFICATIONS Wireless Charger Input: 5V 3A/9V 2.22A/12V/1.67A Charging Mode: 15W Dimensions: 62 x 10.6mm Type-C Power Cable Type-c to Type-c - 1.8 meter PD + QC 3.0 Adapter Input: 100-240V,50/60Hz,0.8A Output: 5V 3A/9V 2.22A/12V/1.67A SAFETY PRECAUTIONS - Use only certified power adapter as provided, non-certified power adapter may cause irregular or no charging. - Do not use products provided for anything other than its intended use. - Use product in location with temperature of 32°F(0°C) - 95°F (35°C), avoid heat source and direct sunlight. - Avoid water contact or any other liquid. If product becomes wet, unplug it from power source immediately. - Do not use product if dropped or damaged in any way. - Any repairs to products should be performed by a qualified electrician only. - Do not place magnetic cards or similar items near the product. - Use specified power source and voltage only. - Place charger on a flat and sturdy surface during use. - Keep product out of reach of children. FCC WARNING STATEMENT The two-part warning label described in FCC 15.19(a)(3), "This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation." This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio and television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. This transmitter must not be colocated or operating in conjunction with any other antenna or transmitter. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Zview-50-0045 Rev 1.0 WIRELESS CHARGER INSTRUCTION MANUAL Slim Case (Within 4mm) Centrally Placed Thickness more than 4mm Crookedly Placed Magnetic Pad No metal objects on pad (Coins, keys, etc..) Metal Ring Case No metal foreign object between device and pad ISED Canada Statement: This device contains licence-exempt trasnsmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada 's licence-exempt RSS(s). Operation is subject to the following two conditions: 1) this device may not cause interference and 2) this device must accept any interference, including interference that may cause undesired operation of the device. Radiation Exposure: This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment RF Exposure Statement To maintain compliance with IC's RF Exposure guidelincs, This cquipment should be.installed and operated with minimum distance of 10cm the radiator your body. This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter Déclaration de l'ISED Canada : Cet appareil contient des émetteurs / récepteurs exempts de licence se conformer à l'innovation, la science et le développement économique Les RSS du Canada exemptes de licence. Leur fonctionnement suivant deux conditions: 1) cet appareil ne peut pas causer d'interférences et 2) ce dispositif doit accepter toute interférence, y compris peut provoquer le fonctionnement indésirable de l'appareil. Exposition aux rayonnements : Cet équipement est conforme aux radiations du Canada limites d'exposition pour un environnement incontrôlé noncé d'exposition RF Pour maintenir le respect des guides d'exposition RF d'IC, cquipment doit être.installé et actionné avec une distance minimale de 10cm le radiateur de votre corps. Cet appareil et ses antennes ne doivent pas être colocalisé ou en opération en conjonction avec toute autre antenne ou émetteurAdobe Illustrator 24.0 (Windows) Adobe PDF library 15.00