EasyLogger Quick Guide

Installation

Version 1 - Straight into the fresh screed

After applying the screed, press the easylogger with your fingers into the still soft/liquid screed until the easylogger is just below the top edge of the screed.

Version 2 - Belated gluing

Drill, with a 35mm drill, an approximately 18mm deep hole into the subsurface and glue the easylogger into the borehole with filler or floor adhesive.

In order to find the device more easily afterwards, the enclosed flag can be used. After placing the easylogger on the surface of the screed, insert the enclosed flag into the smaller hole on the top.

Product Description

The easylogger is a temperature (°C) and humidity measuring device (%RH), on which long-term data records of these measured values are saved. The device is positioned on the screed surface.

With the easylogger, the room climate can be measured directly on the screed-surface during the screed drying and the associated diagram can be displayed.

The data can be read out contactless via radio connection with synchronization using a mobile phone or a PC. The device can be read out up to five times.

App

Read out the easylogger is possible with an own APP, called "easylogger", which is available for Android and Apple-Smartphones in the respective store (Apple-AppStore or Android-PlayStore).

Instructions and further information can be found in the App or on our website (www.floorprotector.at).

Hints

• Always store unassembled easyloggers in the original packaging in a frost-proof and dry place.
• Protect from direct sunlight.
• Do not build in damaged devices.
• Do not open or modify the device.
• Never keep next to magnetic fields.

Certification Information

a) User Information (FCC 15.21): Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

b) Part 15 Statement (FCC 15.19): This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.

c) Statement (RSS GEN Issue 5): This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.

(French translation of c) Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux RSS (RSS) d'Innovation, Sciences et Développement économique Canada. Le fonctionnement est soumis aux deux conditions suivantes: (1) Cet appareil ne doit pas causer d'interférences (2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles de provoquer un fonctionnement indésirable de l'appareil.

Manufacturer: fp floor protector GmbH, Waldgasse 2, A-2700 Wr. Neustadt