Care.ai Ambient Monitoring Sensor

Device Components

• 1 Camera: Captures video feed.
• 2 LED: 18 LED beads for illumination, automatically activate in dark conditions.
• 3 Light Sensor: Adjusts lens brightness based on ambient environment.
• 4 IR Receiver: Receives infrared signals.
• 5 Indicator: LED status light (flashing blue for normal boot, red for quality inspection).
• 6 LAN: RJ 45 network cable interface for connecting to a local network.
• 7 RST: Reset button; requires a long needle object and pressing for more than 5 seconds to reset.
• 8 USB: Interface for connecting external devices like mice and keyboards.
• 9 TYPE-C: Used for manufacturers and engineers for upgrades; not recommended for consumers.
• 10 HDMI OUT: Outputs video signal to an external display for camera playback.
• 11 HDMI IN: Inputs external video data into the camera.
• 12 IR: IR transmitter for sending relevant signals.
• 13 DC IN: DC power input for supplying power to the machine.
• 14 ON/OFF: Interface to switch the device on and off while DC power is supplied.

Operation and Features

Power On and Video Admission

After the power supply is connected, the camera will automatically turn on and begin video admission for further operations.

Illumination and Brightness Control

The device features 18 LED beads that provide illumination. These LEDs automatically activate to fill the light when the environment becomes dark. Additionally, the light sensor hole automatically adjusts the lens brightness according to the current use environment.

Signal Reception and Transmission

An infrared wireless reception stage is present, designed to receive signals from the IR transmitter (item 12) located at position 12.

Status Indicator

The machine's LED status indicator light provides visual feedback. A flashing blue light signifies a normal boot process, while a red light indicates the device is undergoing quality inspection.

Connectivity and Usage

The RJ 45 network cable interface connects the device to an external local network. The USB interface supports external peripherals such as mice and keyboards. The Type-C interface is designated for manufacturers and engineers for system upgrades and is not recommended for consumer use. The HDMI OUT port allows for video playback on an external display, while the HDMI IN port can receive external video data. The DC IN interface provides power, and the ON/OFF interface controls the device's power state.

Regulatory Information

FCC Warning

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.