User Guide for VETEK models including: OCS-V High Resolution Digital Crane Scale, OCS-V, High Resolution Digital Crane Scale, Resolution Digital Crane Scale, Digital Crane Scale, Crane Scale
Crane Scale OCS-V with LED display and hook - 1 tonne/0,5kg - Vetek
Krokvåg OCS-V med LED display och krok - 5 ton/2kg - Vetek
OCS-V User Guide Manual_OCS-V_V1 ENG High Resolution Digital Crane Scale User Guide For good performance and precise measurement, be careful with daily operation and maintenance. Do NOT overload scale. This will damage loadcell and void warranty. Do NOT leave load hung on the scale for long. This will decrease scale's accuracy and shorten loadcell's life. Inspect shackle and hook before using. Check clips, pins and screws regularly. Check battery frequently. When scale runs out of power, replace the dead batteries with new ones. Rotate load rather than scale if needed. Do NOT use scale under thunder or rain. Hang scale on shelf in dry and well-ventilated room. Do NOT place scale on the ground directly. Do NOT attempt to repair scale yourself. Contact your local representative. Do NOT use external chargers, Use the original DC5V charger. Specifications Accuracy Tare Range Zero Range Stable Time Overload Safety Load Battery Battery Life Display Chinese GB/T 11883-2002 CIII eqv. OIML R76 100% F.S. 4% F.S. 10sec 100% F.S. + 9e 120% F.S. 18650 lithium battery DC5V charger >20hour 115*41mm LED display Page 1 of 4 High Resolution Digital Crane Scale Op. Temp. -10 ~ +40 User Guide Display & Keys Scale Keys Key Name Function Power-on On/Off Power-off Zero Zero Hold Lock/unlock Tare Tare in/out Remote Keys Key Name Function Zero ZeroChange digit Tare Tare in/outMove digit Hold Lock or unlockConfirm &Next Page 2 of 4 High Resolution Digital Crane Scale Acc. 2nd functionChange digit User Guide Del. 2nd functionMove digit F1 2nd function F2 Unit Switch Off Long press to power off 2nd 2nd function User Setup Press first then press shows. to enter User Setup menu. Auto-Off Timing Press to enter Auto-Off Timing. shows. Press or to change timing value. Auto-Off Timing can be set to: (disabled), (5min), (10min), (15min), (30min), (60min). Display Brightness Press Press br to enter Backlight Brightness. --- shows. or to change brightness value. Display Brightness can be set to 0-7 levels. Press Press Idle Mode Timing idE to enter Idle Mode Timing. --- shows or to change timing value. Page 3 of 4 High Resolution Digital Crane Scale User Guide Idle Mode Timing can be set to: 0(disabled), 5(5sec), 10(10sec), 15(15sec), 30(30sec), 60 (60sec). It is 30sec by default. Press to exit User Set. Page 4 of 4Justin Adobe PDF Library 24.2.159