Raoping Minghui LC-040 BT Car Charger Instruction Manual
30W (Max) USB-C PD Port
Compatible with most Type-C interfaces, including iPhone 15, iPhone 16, and Samsung mobile phones.
30W (Max) Lightning Port
Supports charging for Apple devices via a Lightning cable.
120W (Max) USB-A Port
Compatible with most domestic products using a Type-C interface.
USB+PD Expansion Port
PD port supports 5V/3.0A output. USB port supports 5V/3.6A output.
Method of Use
-
Step 1: Insert the CAR Bluetooth player into the cigarette lighter.
-
Step 2: Bluetooth Pairing
Access your phone's settings, navigate to "Bluetooth," and select "Bluetooth" for connection. A voice message will confirm when the connection is made.
Example: Phone displays "Audi_MMI_3109" and "Bluetooth Connected."
-
Step 3: FM Frequency Synchronization
The car charger's FM frequency should match your car's radio frequency for audio playback.
Method 1: If the car charger displays "87.5", tune your car radio to "87.5 FM".
Method 2: Tune your car radio to an empty frequency with no signal, then set the car charger to the same frequency.
Example frequencies: 83.2MHz, 98.5MHz.
-
Step 4: Play Music
Open the music player on your mobile phone. The music will play through your car's sound system.
MP3 Playback from U-Disc
After synchronizing the FM frequency between the device and car radio, insert a U-Disc into the blue USB port to enjoy MP3 playback.
- To pause music, short press the pause button [▶️]. Press again to resume playback.
- To skip to the previous song, short press "PRE/V-".
- To skip to the next song, short press "Next/V-".
- To adjust volume up, long press "Next/V-".
- To adjust volume down, long press "PRE/V-".
Specifications
| Parameter | Value |
|---|---|
| Working Voltage | DC 12V-24V |
| Support U Disk Capacity | <32GB |
| FM Frequency Range | 87.5-108.0MHZ |
| Built-in BT | V5.0 + EDR |
| Wireless Transmission Distance | 10M |
| Wireless Profile | A2DP, AVRCP, HFP |
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
RF Exposure Statement
To maintain compliance with FCC's RF Exposure guidelines, this equipment should be installed and operated with minimum 20cm between the radiator and your body. This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.