Hitron CODA-4582 / 4682 / 4782 Manual

Hitron CODA-4582 / 4682 / 4782 Manual


1. Connect t o t he net work
2.Set up your wireless net work

Check the Box Contents

STEP 1: Look in the box and make sure you have the following:

The Hit ron CODA-4582/ 4682/ 4782 is an application gateway that provides wired and wirel ess high-speed Int ernet access as well as optional MoCA (Multimedia over CoaxAlliance) net working to the Ethernet -enabled devices in your home f or a fast and easy home entert ainment network.

Connect to a Cable Outlet

STEP 2: Use a coaxial cabl e (not included) to connect the device’s CABLE connect or to a cable outlet.

Connect to a Power Outlet

STEP 3: Use t he power cord provided t o connect t he POWER port to a power outlet.

Connect to an Ethernet -Equipped Device (Optional)

STEP 4: Use the Ethernet cable provided to connect one of the LAN ports to an Ethernet -equipped device.

User Configurat ion (Optional)

STEP 5: In a web browser, enter in the address bar followed by Username and Password, as below.

Connect wit h Wireless Devices (Optional)

STEP 6: Connect your wirel ess devices wit h t he correct SSID and Passphrase. If you have not changed them, the default values are indicated on the sticker on the back of the unit.
Connect your wirel ess devices wit h t he WiFi Prot ected Setup (WPS). Access the configuration interface (seestep 5), enter the Wireless page to enable WPS and set Encrypt Mode to AES, then press Save Changes. Press this button to begin the WPS Push-Button Configuration (PBC) procedure. Press the PBC button on your wireless clients in the coverage area within two minutes to enable them to join the wireless network.

Setup Complete

STEP 7:Congratulations! You have successfully setup your CODA-4582/4682/4782. If you have any problems, see the section below for help in identifying the cause.

IP Addresses

If the CODA-4582 is successf ully connected to the network (see LED Display) but you cannot access the Int ernet from a connected computer, your computer’s IP Address may be setup improperly. In your computer’s network settings, ensure that it is configured to either receive an IP address automatically (recommended) or that it has a static IP address in the range. For more information, consult your operating system’s Help documentation.

LED Display

Safet y Warnings

Rsk or electrical SOCK·Do not expose the device to water or mosture The device is a hign-performance communications device designed for home and ottice environments. Do not use tne device outdoors. Keep the device In an environment between O CN 40 C (32 F 104°F). To avold overheating, do NOT place any Object on top or the device. Do not restrict the ↑low of alr around the cable modem. The manufacturer assumes no llablitiestor damage caused by any improper use of the device
The manufacturer assumes no llabllties with respect to the contents of this document. The manufacturer als0 reserves the right to revise this document or update the content thereor without any obllgation to notity any person of such revis ons or amendments Specificaions subject to change without notice
The cable distribution system should be grounded (earthed) in a accordance with ANS NEPA 70, the Nationa日ectrical Oode (NEC. In particular Section 820.93, rounding ol Outer Oonductive snleid Coaxial Cable .

FCC Statement
Federal Communlcatlon Commlsslon Interference Statement
This equlpment has been teted and found to comply with the limitsfor a Ciass B dlgltal device, pursuant to Part 15 of the FOC Fules These llmits are des gned to provide reasonable protection agalnst harmful Interference In a resdential Instalation. This equipment generates, uses and can radlate radlo trequency energy and, t not Installed and used In accordance with the Instructions, may cause harmfu Interference to radio communlcations.
However, there is no guarantee that Interference wll not occur in a particular Installation. If this equipment does cause harmful Interterence to radlo or televsion receptlon, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the Interference by one of the following measures

1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.

FOC Caution: Any changes or modifications not express y approved by the party respons ble for compliance could vold the user’s autnority to operate thls equipment

This device is going to be operated in 5.15-5.25GHz frequency range, Isrestricted In Indoor environment only.

This device complles with Part 15 of the FOC Rules Operation is subject to the following two conditions (1) This device may not cause harmful interterence, and (2) this device mus accept any Interterence recelved, Including Interterence that may cause undesred operation. For product aval lable in the USA Canada market, only channel 1~11 can be operated·Selection or other channels is not possible This device and it’s antennas s must not be co-located or operating In conjunction with any other antenna or transmltter except In accordance with FoC muit-transmitter product procedures.

FCC Radlatlon Exposure Statement:
This equipment comples with FOC radiation exposure imits sat ↑orth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 21cm between the radiator & your body.
IC Statement:
This device compl es with ndust ry Canada license exempt RBI st andard s er ation s sub ect t o t he ↑ | owi ng t wo conditions: 1 this de ce may not cause Interte ence, and 2) thi S de ce must accept any int ert erence including Int ert erence t hat may cause undesred operation of the device.

Le présent apparev est conforme aux CNR dindustrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditons suivantes: (1) lapparei ne doit pas produire de broumlage, etde lappareil doit accepter tout brouilage radioślectrique subi, même sile broulage est susceptible den compromettre le fonctionnement.

For product avalable in the USA Canada market, only channel 1 11 can be operated. Selection ot other channels is not possible.

Pour les produits disponibles aux Etats-Unis/ Canada du marché, seul le canal 1 à 11 peuvent être expbités. Sélection d’autres canaux n’est pas possible.

This device and it’s antennass) must not be co-located or operat ing in conjunction with any other antenna or transmitter except In accordance with i multi-transmitter product procedures.

Cet apparei et son antene (s) ne doit pas être co-locaisés ou fonctionnement en association avec une autre antenne ou transmetteur.

The device for the band 5150-5250 MHz is only for Indoor usage to reduce potential for harmful Interference to co-channel mobilesatelte systems.

Les dispositifs fanctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une utilisation à ntérieur afin de réouire les risques de brouilage préjdiciable aux systèmes de satlites mobies tiisant les mêmes canaux.

IC Radlatlon Exposure Statement:
This e uipment compiles with CRSS102 radiation exposure imits sat ↑orth for an uncontrolled en ronment. This equipment should be installed and operated with minimum distance 21cm between the radiator & your body Cet équipement est conforme aux limites dexposiion aux rayonnements IC établies pour un environnement non contrôlé. Cet équioement doit être installé et utilisé avec un minwmum de 21 am de distance entre la source de rayonnement et votre corps.




Leave a comment

Your email address will not be published. Required fields are marked *