HINKLEY 1500SMT Transformer

Transformer diagram

Mounting Instructions

start here

1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
   1. First plug photocell jumper (3) in (if needed)
   2. Next knockout conduit knockout in order to create an opening for dimmer box (1)
   3. Secure dimmer box (1) to transformer using lock ring (2). Wires from dimmer box should run through the conduit knockout.
   4. Connect key connectors form dimmer box (5) and daughter board (6) together.
   5. Connect the free wires from the dimmer box into the COM and 12V terminal block connectors (8)
   6. Connect light fixture wires to the positive and negative terminals at the end of the daughter board
      Note: fixture wire can larger then 10 gage cannot be used on the daughter board. The board also features two positive and negative terminals to run multiple fixture lines. Wire zone 1 fixtures to Z1+ and Z1- and wire Zone 2 fixtures to Z2+ and Z2-.
   7. Use wall plug (4) to power on transformer
   8. Download the Hinkley app to control dimmer settings. Refer to page 2 for app instructions

33000 Pin Oak Parkway, Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkley.com

Documents / Resources

HINKLEY 1500SMT Transformer [pdf] Instruction Manual 1500SMT Transformer, 1500SMT, Transformer

References

• User Manual