क्रेमर केडॉक-4-होल्डर मल्टीपॉर्ट एडेप्टर
केडॉक-1/2/3-होल्डर
Congratulations on purchasing your Kramer KDOCK-1/2/3-HOLDER / KDOCK-4-HOLDER for safely securing KDock USB-C Hub Multiport Adapters below or on a surface. This document describes how to secure the KDOCK-1/2/3-HOLDER and the KDOCK-4-HOLDER to a surface.
Installing the KDOCK-1/2/3-HOLDER
KDOCK-1/2/3-HOLDER can be installed either under or above a surface. In this example, it is installed under a table.
To secure the KDOCK-1/2/3-HOLDER under a table:
- Insert the KDock device into the clamp, in-between the rubber pads.
- Insert a washer (supplied) and then a nut (supplied) onto each of the studs and tighten.
- Check the location under the table where you want to install the device and mark the location for the two installation screws (supplied).
- Use the two installation screws to secure the KDOCK-1/2/3-HOLDER under the table.
Installing the KDOCK-4-HOLDER
KDOCK-4-HOLDER can be installed either under or above a surface. In this example, it is installed on a table. Note that when it is installed under, the flip-up device holder cannot be used.
To secure the KDOCK-4-HOLDER on a table:
- Place the KDock-4 device on the surface, at the correct location.
- Place the KDOCK-4-HOLDER over the device.
- Insert the four screws and secure the KDOCK-4-HOLDER to the table.
तकनीकी निर्देश
| पर्यावरण की स्थिति | परिचालन तापमान | 0° से +40°C (32° से 104°F)। |
| भंडारण तापमान | -10° से +55°C (14° से 131°F) तक। | |
| नमी | 5% से 90%, आरएचएल गैर-संघनक। | |
| विनियामक अनुपालन | सुरक्षा | सीई। |
| पर्यावरण | RoHs | |
| दीवार | सामग्री | Zinc-coated steel and rubber padding (for
केडॉक-1/2/3-होल्डर केवल) |
| सामान्य | शुद्ध आयाम (डब्ल्यू, डी, एच) | केडॉक-1/2/3-होल्डर: 3cm x 6.5cm x 1.9 cm (1.2″ x 2.6″ x 0.75″) Approx. |
| केडॉक-4-होल्डर: 26.2cm x 7.1cm x 2.5cm
(10.3″ x 2.8″ x 1″) Approx. |
||
| शिपिंग आयाम (डब्ल्यू, डी, एच) | केडॉक-1/2/3-होल्डर: 12.1 सेमी x 8.2 सेमी x 4.1 सेमी (4.8″ x 3.2″ x 1.6″) | |
| केडॉक-4-होल्डर: 36.6cm x 21cm x 7.7 cm (14.4″ x 8.27″ x 3″) | ||
| निवल भार | केडॉक-1/2/3-होल्डर: 50g (0.11lbs) approx. केडॉक-4-होल्डर: 201g (0.44lbs) approx. |
|
| नौवहन वजन | केडॉक-1/2/3-होल्डर: 90g (0.2lbs) approx.
केडॉक-4-होल्डर: 261g (0.6lbs) approx. |
दस्तावेज़ / संसाधन
 |
क्रेमर केडॉक-4-होल्डर मल्टीपॉर्ट एडेप्टर [पीडीएफ] निर्देश मैनुअल केडॉक-1-2-3-होल्डर, केडॉक-4-होल्डर, केडॉक-4-होल्डर मल्टीपॉर्ट एडेप्टर, केडॉक-4-होल्डर, मल्टीपोर्ट एडेप्टर |
